Obviously, a pin on bucket, since added the BL-1767 Quick-Tach from Kubota. I'd like to get the pallet forks. L2077A frame and K9048 forks, but the whole setup will cost $1K U.S. plus shipping to the nearest dealer. Then I have to pick it up.
There are others that make pallet forks, but I must supply the dimensions. Not a big deal, but I'd have to borrow the appropriately sized micrometer to measure over the 1" pins for an accurate center to center distance. Again, not a big deal, but then I have to worry about the vendor accurately placing the holes, on my dime!
Does anyone here have the Kubota fork frame system, or has anyone had another Vendor accurately make a replacement?
I will have forks!
Thanks..
There are others that make pallet forks, but I must supply the dimensions. Not a big deal, but I'd have to borrow the appropriately sized micrometer to measure over the 1" pins for an accurate center to center distance. Again, not a big deal, but then I have to worry about the vendor accurately placing the holes, on my dime!
Does anyone here have the Kubota fork frame system, or has anyone had another Vendor accurately make a replacement?
I will have forks!
Thanks..