I removed the bolts holding the tool box, got 1 1/2 inch bolts and bolted on the two Blazer LED lights under the tool box pointing to the rear. Connected to the spare 12v connection under the left fender and installed a switch in the handle spot of the cup holder. Protected there. The lights only come on if the main lights on and the switch in the cup hilder on. works great! Chris
I got two Blazer CWL503 LED Round Work Light - Clear, 18 watts each. Purchased a switch (waterproof) a relay and fuse. Plan to install on rear fenders pointing backwards for when snow blowing. I looked under left rear fender and discovered an extra aux plug not used that is always hot (has white female connector). When at the Kubota dealer they stated it was fused and would easily handle the two lights. Thought I would get a second opinion here before I return the relay. Has anyone just connected to this wire? Unfused as it is fused to the rear running lights. Thanks, Chris
PS I read the thread on adding light bars to the top of the ROPS but that is a lot more light than I am connecting
I got two Blazer CWL503 LED Round Work Light - Clear, 18 watts each. Purchased a switch (waterproof) a relay and fuse. Plan to install on rear fenders pointing backwards for when snow blowing. I looked under left rear fender and discovered an extra aux plug not used that is always hot (has white female connector). When at the Kubota dealer they stated it was fused and would easily handle the two lights. Thought I would get a second opinion here before I return the relay. Has anyone just connected to this wire? Unfused as it is fused to the rear running lights. Thanks, Chris
PS I read the thread on adding light bars to the top of the ROPS but that is a lot more light than I am connecting
Last edited: