Hello All! I am a new user to Orange Tractor Talks, so please bear with me!
I have poured over threads, and have not found anything to helpful, so perhasp i have missed one, please excuse me for that!
I have a Kubota B7200 HST with a B1640A FEL. I am experiencing some problems with the 3Pt however. It will cycle fine under no load. I tried using my tiller, and it would only lift about 2 inches max. However, if i assisted it by pulling up on the top link it would lift all the way. Then I dropped the tiller and put on the straight blade to do some leveling/dirt work. At first it lifted fine, with no hesitation or any problems. Then one time it wouldn't lift at all, not even an inch. I played with the lift and the loader at the same time and when i curled the buckets slightly, the 3pt came up. The loader works fine, with no problems.
I have changed the hydro fluid and filter recently and I overfilled it slightly. When i fired it up and let it run for a few minutes, when i shut if off fluid came pouring out of the TOP of the 3pt housing. Is there an over flow vent or did i blow a seal? Since then, it has not overflowed or spewed any fluids.
Can someone please help me out with this!
Thanks,
Chris
I have poured over threads, and have not found anything to helpful, so perhasp i have missed one, please excuse me for that!
I have a Kubota B7200 HST with a B1640A FEL. I am experiencing some problems with the 3Pt however. It will cycle fine under no load. I tried using my tiller, and it would only lift about 2 inches max. However, if i assisted it by pulling up on the top link it would lift all the way. Then I dropped the tiller and put on the straight blade to do some leveling/dirt work. At first it lifted fine, with no hesitation or any problems. Then one time it wouldn't lift at all, not even an inch. I played with the lift and the loader at the same time and when i curled the buckets slightly, the 3pt came up. The loader works fine, with no problems.
I have changed the hydro fluid and filter recently and I overfilled it slightly. When i fired it up and let it run for a few minutes, when i shut if off fluid came pouring out of the TOP of the 3pt housing. Is there an over flow vent or did i blow a seal? Since then, it has not overflowed or spewed any fluids.
Can someone please help me out with this!
Thanks,
Chris