My wife said she could not get the bucket back on the tractor last night, I stopped and looked on my way to work this morning and the two pieces that connect to the bucket are about 6" out of sync, I didn't see anything obviously bent but________. Any thoughts? Kubota M8580 with 1301 loader
1301 loader
- Thread starter theron19
- Start date
Just cycle bucket tilt to put them back in line. If you push on one the other moves. Because cylinders are t'd into each other.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Are you talking about the quick attach?
It's possible to bend the tube that connects the two plates together.
If one pin is aligning and the other isn't, then put the plate that's further forward up against something solid and roll the loader forward till the plates are in alignment again.
It's possible to bend the tube that connects the two plates together.
If one pin is aligning and the other isn't, then put the plate that's further forward up against something solid and roll the loader forward till the plates are in alignment again.