It was time to pull the filter and clean it and after replacing it there was no action on either the loader, 3point and the power steering very hard. So i pulled the filter again to check and the housing was still empty (after 15 minutes of running prior). I was thinking there was an air lock so i filled the sump of the filter and reinstalled and another 15 minutes and no action on the hydraulics.
It seems the hydraulic level is fine, if not a little overfull so there is plenty of fluid. It seems as if there is no suction from the pump up through the filter.
It was working prior to pulling the filter out to clean it. is there some relief valve or something that may be stuck open and not allowing the suction up from the transmission as that seems to be whats happening but I don't know the hydraulic system well enough. any suggestions greatly appreciated.
It seems the hydraulic level is fine, if not a little overfull so there is plenty of fluid. It seems as if there is no suction from the pump up through the filter.
It was working prior to pulling the filter out to clean it. is there some relief valve or something that may be stuck open and not allowing the suction up from the transmission as that seems to be whats happening but I don't know the hydraulic system well enough. any suggestions greatly appreciated.