Search results

It looks nice. You might want to check the chains they look like they are on wrong, where the links attach to the side chain that circles the tire should have the hooks facing the outside of the tires. Yes you run them this way but the end links will rub places into the tires after a while. I...

You might want to keep your eye on the date and make sure if you have a good finance rate that it will not expire before the tractor is delivered. Good luck with the new tractor.

Thanks for the comments. I did go ahead and try it on scraping the gravel on my driveway and it worked great no problems at all. With the BH on the back it seems to balance the weight out very good. Yea it is a lot of iron but it is not a lot more than an empty fel and with the BH on it it is...

I agree with the above post take them off if you will not be traveling down the road. The reason I say this is I just looked at them on Kubota's web site and yes they do stick out it looks like to me it would be tough to make someting to protect them but not impossible. But when you do make...

I got the grill guard painted and the expanded metal painted also. I think it is now done it's been quite a project and now I just have to wait for the snow.

On my B2620 it has the same exact style bracket as in your picture and the lever goes all the way down and the bracket just rotates to lock the lever in place. I know it was not the model you were asking about but my instructions say the same thing to have the lever in the down postion. Hope...

I am almost done now.............. I have got the grill guard almost done just a little paint so I thought I would post a couple of pictures. I made it where I am going to bolt the expanded metal in place and it is also pretty much flush or inset into the orginial piece. What should I paint it...

looks nice............:cool:

It is getting closer to being done. I just need to repair the grill guard where I had to cut it because I added thickness to the frame rails. I am going to weld a piece in it and then weld angle iron on the bottom of the bars and add one piece down lower and bend it the same contour of the outer...

Thanks for the comments. I got everything painted today now it just needs to dry. I bought the hose's and fittings yesterday so hopefully Saturday I will have it finished.

Just a little more to go. I need to do some more metal work, paint and then get the hose's made. The blue paint was just to keep it from rusting while I had other things to do.

Looks good.

It is a good idea but I wonder if extending the rear hitch so far back would cause you to get the ft. end light. If I was to build one I would make sure I did not hook up to anything very heavy.

Looks nice.

No they only require 12 volts and I picked up the factory wires under the rear fender. The wireing is pretty straight forward just ran and hot and ground to each light I did open up the harness and ran the wire to the other side inside the existing loom and then buttoned the loom back up. By...

Here is a few more with paint. I need to come up with a rod for the ft. belly mower to release the linkage and no matter what I did with the lower brace's I still have a clearance issue with the tires granted its when the axle is as far as it will go down and the steering turned as sharp as you...

A little more progress I am almost ready for some paint.

I think you have the bh65 BH on your tractor. It has two rubber bumpers one each side that when swinging from side to side that stops the boom from going to far. I think the rubber may be worn to much letting you swing until the piston in the cly. covers the port and then with the port closed...

Another update on progress. I got my rear brackets cut out now I need to drill some holes.