Search results

I have a newer L3200 with 160 hours on it. I have two acres that turns to a weed patch every spring. While operating my brush hog at 500-540 RPM, I get about 3/4 of the way done and engine power starts rapidly dropping off as if it is fuel starved. I have checked and replaced the fuel filter...

The manual for the L3200 gives you a chart for which hole to use with which implement. Perhaps the manual for yours has the same information. Good Luck.

Just a thought about pin lubrication. A read a post from a smart feller who said to use spray graphite rather than spray grease. It won't attract as much dirt. Seems like a good idea.

Thanks for your input. I am learning from each post. I believe the way to go about this is to see if P and T "beyond" ports are available on my FEL valve. I believe they are. I would then run hoses as protected as possible from the FEL valve to the dual 4/3 valve. I have seen dual valve...

P.S. - I just went to the Fitrite site and it looks like it could be very useful. Thanks again for your help and time. Larry P.

Thanks for your speedy reply. I went to Pauley (Escondido) and they quoted me close to $1200 and that didn't include the labor of +/- 4 hours or hoses. I took some photos of a larger tractor with top and side hydraulic cylinders and it was a very simple installation with the valve mounted on a...

I would like to add a hydraulic top link and right-side lifting link. I have many questions. Is there a standard for farm equipment hyd. cylinders? Is there a preferred method to connect to the auxilliary block. (I have a loader.) I am thinking of splicing into the "To Implement" and "From...