Search results

I am the third owner of a B8200 Kubota with a mid mount mower. Before I started to mount the mower I thought I'd better take off the mid mount PTO shaft cover to make sure it actually turns. Which to my surprise it didn't (however the rear PTO does turn). After I drained the hydraulic fluid...

I want to get a new battery for my B8200 Kubota diesel. I am finding there are many cranking amp options available. One option is 936 cranking amps with 750 cold cranking amps. My first thought is the higher the amps the better the diesel engine will start. Then the other side of me...

I want to replace a ratty looking radiator hose on my Kubota B8200 that does not show up on the parts list. Can anyone identify the hose in the attached photo? It is the one with the deteriorating stringy looking threads that goes from the bottom of the engine horizontal to a connecting tee...

I am trying to replace wiring behind the gauge and light switch panel on my B8200. I have removed the two bolts on the underside of each side near the front corners. Something seems to be still holding and I cannot see what it is. Does anyone know what I am missing? Thanks.

The owners manual for B8200 says to open bleeding screws on top of fuel filter two turns until bubbles disappear then tighten. Then open open the air vent plug on the fuel injection pump and turn engine (with stop button pulled) for about 10 seconds. Close the air vent when air bubbles...

I have a fuel leak where the three fuel line adapters connect to the top of fuel injector pump on my Kubota B8200. I tried to tighten the fuel line nuts above the adapters and none seemed loose. However this must have disturbed the adapters below and I can now see the adapters connected to the...

In bought a used Kubota B8200 diesel tractor and the engine idles at about 1,000 rpm's. Engine model is D950-A-DT. Is that about the right rpm's or should it be lower? Can't find any mention of it in the owners manual. Also trying the figure out the year this tractor was made. The...

I need to replace bearings on the right spindle. I have the top nut, lock washer and regular washer removed but the pulley will not lift out as it is held in by a feather key. How do you remove this feather key?