Search results

Great, thanks Dan

All sounds good except for one thing - the N port on the summit valve gets a power beyond sleeve and is used to power the backhoe. It is the tank port that would be routed to the tee - correct?

So, there is an outlet extension I may end up using instead of buying the pipe and rigging something together which I am assuming is OK. It is $162 and the pipe is only $30 though and some extra parts so will take a look. But since I have to remove the cover any way I could add this extension...

Thanks Guys, that is helpful - I have a plan now. Also, once I get the fender and wheel off it will be easier to see where everything goes.

I am about to add rear remotes to my LX2610 - I already have a 3rd function and backhoe. I have it basically figured out (thanks to Dan/Thisoldhokie !) and found some information. The way the LX2610 is configured, PB off the loader valve goes to the third function, which then feeds the backhoe...

By loose - there was no pressure on the pins on the left side cylinder - there was "play" meaning the cylinder wasn't putting pressure on the pins on that side.. After closer inspection I totally missed something - the bar accross the boom on the quick hitch is bent. Whatever I did bent that...

I was doing some work today with the Grapple and all of a sudden my loader was crooked. When I checked it the left side cylinder for curl was loose on the loader. The other right works and the bucket will curl, but no mater what position it is in the left side cylinder is loose and I am...

Thanks, that makes much more sense, especially the fact that the kit is not configured for true PB. It also makes sens that the Manual valves have a port (N) that is used to get PB working on them. Thanks for the info - very helpful.

Thanks - yes, I should have included that - I did know the outlet goes to the 3pt first. Yes, and it makes sense there really wont be enough power for the remotes when the backhoe is on, but that is OK. I am using the Summit hydraulic block kit (link below). It looks like it has two work...

Long post, but bear with me, I want to add rear remotes to my LX2610. I have done some research and think I have the right solution, but want to run it by folks before I do. Important to note that I already have both a backhoe (BH77) and a Kubota 3rd function valve installed. There is a...