Search results

last year my tractor started making squealing noises on occasion when going over uneven ground. the propeller shaft tube that goes from mid pto drop to the front axle is smoking hot to the touch and does not look perfectly aligned . i want to pull the shaft to inspect. there is ( was) a roll pin...

I would like to replace the seal on the pump and I think that hydraulic oil is leaking into my crankcase. I've read numerous posts about having to replace the pump entirely . Does anyone have any experience repairing/rebuilding these pumps and if it's worthwhile? Thank you

I'm going to be removing the loader from my l2250 and had a look at it tonight . I labeled the quick connect hoses that go into the control in the cab and put the stabilizer bars in the bucket. The wedge bolts on either side I'm assuming I undo the nuts and tap them out or to they just need to...

i went to start my tractor today and the low coolant level light came on. i shut the tractor off and checked the coolant resevoir and it was at the low mark. since there was no obvious extermal leaks i pulled the oil dipstick and the coolant was right to the top. im assuming ive got a blown head...

Hi. I havent been on here in a while as ive had no issues with my tractor. it was running well for the past year. i was using it and then shut it off to go and do something and when i came back it wont even attempt to turn over. the battery is only a few months old as the old one was leaking...

so i took my tractor for a 1/2 hour drive the other day to pick something up and noticed and squealing noise begin from the mid area of the tractor . after pulling over i checked underneath and the driveshaft coming from what im assuming is the transfer case is extremely hot to the touch. im...

i borrowed a neighbours rotary mower to use on my l2250 and when i went to use is i couldnt get the pto engaged. i pressed the clutch and had everything in neutral and was just getting grinding noises when i tries to engage in either 540 or 1000 pto setting. if i shut the tractor off and engage...

i found the sight glass for the oil level on the side of the transmission by the clutch pedal and noticed it was not visible in the sight glass. i just picked this unit up from auction. i went to the local kubota dealer and got some premium udt which is what they recommended. do i just fill from...

im just curious how to determine the year of tractor i have? its an l2250dt

I bought another L2250 for a steal at a local auction one thing I noticed when I got it home was it seems to be leaking oil from both front wheels on the front differential. I noticed that on my first tractor there is what looks like a 4 inch black plastic breather tube threaded into the one...

just picked up a kvp-20t water pump and 400 feet of hose at auction. does anyone have experience with these units. i havent gone over it to see if it works yet. i noticed its missing the air c;leaner cover and am hoping to source a new one

ive noticed that my l2250 smokes on cold weather startup until it gets warm. is this normal? no black smoke just grey

i shut my tractor down with the front end loader raised and noticed that it lowered over a few hours. is that normal. i dont typically keep the bucket raised but got side tracked

im wondering what the proper warm up procedure is one my l2250. i keep the block heater plugged in for a few hour prior to start up. should i run it at idle until it warms up or mid throttle? how long should i run it for?

i noticed there is what appears to be an inline coolant heater on my l2250. im used to the type that insert in the frost plug hole on the engine block in a car. does this one heat the coolant and circulate it as well? how long should i plug it in for prior to use or should i just leave it...

New owner here. I'm looking to do an oil change on my recently purchased l2250. What kind of oil do I use and how much? I'm assuming the drain plugs are the 2 plugs at the bottom of the drain pan

im a new member here. i just bought a l2250 with loader and front mount snow blower does anyone have a downloadable version of the owners manual and service manual. there was a warning light on and it appears to be coolant level but the rad was full