Search results

Have a B7000. Temp today 15. Hard turning over, glow plug indicator light not visible. Hook upped battery charger showed sending aprox 4amps to battery which would indicate to me battery was charged. Hit glow bug switch and charge went up to aprox 8amps, glow plug indicator on dash went to a...

I have a B7000 Owners manual speaks to using a snow blower. Has anyone mounted one and if so pros and cons. Price?? Any pictures out there? Thanks Ron

My B7000 has throttle creep. Is there a easy fix? Have tried dirt and spray adhesive at knob closest to drivers seat but problem still exist. Is there a internal friction ring mounted on the motor? Second item--cannot get tractor out of 4wd unless I reaaallyyyy pull hard on lever--don't want to...

Have a B7000, rear tires slide on shaft and have a pin with cotter key that goes through shaft to hold rim on. These rims also have two bolts each with springs and lock washer that tighten rim to shaft. Is there a specific torque and also if not what is there function? Thanks Ron

I am looking to buy a post hole driller for my B7000. Do they exist? What is the averager price? I am in WA state. Am I farther ahead to buy a one man prtable? Any info helpfull.

My glow plug indicator in the dash is only visable at night. During the day if used I cannot see. Do I need a new indicator? If so is the B7001 a match?

Do I need to have a exact match when I add fluid after replacing the hose. Just had fluid changed this spring!

It looks like a fill for fluid to protect the u joint inside, yet ops manual is silent.

I could not figure out how to up load picture. So I will try to descibe what I am looking at. The drive shaft that feeds the front end comes down into a rubber boot. This boot is attached to a small type pan that has a bolt sticking out ( aprox 5/16) I am assuming for checking oil/gear oil...

I am a new owner and proud happy owner of a B7000. Bought in Feb of 2011. During the past month I have been performing some maintance and found the following. Rear tires had no air pressure reading, I filled to 25lbs pressure. While adding the air to the back tires I noticed the rims were...

There was a price list sent out on ROP. The B7000 was not on the list but B6000 and B7100. Will these fit my B 7000.

How much weight should I hang off the back on the three point hitch? Does the three point hitch have a limit? Moved aprox 340 lbs in FEL (sacks of concete and back blade) today. Went down a slight incline and the back wheels came off the ground at the bottom of the hill. Had to lower bucket to...

B7000 Today had replaced one front tire. It is a Starmark 5.00-12 TR 60. Tire on other side on front is Nanking 5.00-12 There is some variation in tread. Is this a problem or since I am dirt no asphalt it is not a problem.Rarely use 4 wheel drive except for when in mud and close to stuck. I...

-------------------------------------------------------------------------------- Ran tractor last week for about 4 hrs moving twenty yards of sand. Did not notice the tractor grabbing into gear. Ran today 02-13-2011 and noticed even when letting clutch out slow it would try to grab into gear...

Ran tractor last week for about 4 hrs moving twenty yards of sand. Did not notice the tractor grabbing into gear. Ran today 02-13-2011 and noticed even when letting clutch out slow it would try to grab into gear. It was like bam into gear you could feel the rear end go into gear.. At the end I...

Have small 2 cylinder Kubota. The bucket wont curl back when loaded with aprox 200 lbs. It has one cylinder located at the bucket. It has two on the arms and no problem lifting a load. Any thoughts on what to try / .

My Kubota parts manual shows part # 66611-5710 for drag link. Does anyone have a different parts numer? For the Kubota dealer I am going through says that number is no good. Thanks

Recently paid $2500 for gray market with front end loader and back blade. Good shape, stored under cover and most things work. PO informed me that when ordering parts a B7100 DT is the same. I am looking for a owners maintence manual and or in depth shop manual. I believe this was built around...