Search results

I need to isolate the EGR/cooler to be able to pressureize the radiater. Iconnected the two 7/8 hoses coming from downside of the engine block. When Radiater was pressurized water exited where one of the two hoses had been. Specificallly the hose fitting on end of cooler at bottom, away fron...

1st, Want to Know If I can reroute the hoses on the EGR/intercooler/? I was told today to take the two hoses and join them together thus bypassing the EGR/intercooler? I looked at it today and I think it can be done but want advice for learned people like yourselves? 2nd. From learned person was...

Does the Kubota V3307-Di-T-E3-B have sleeves in the engine to be replaced? Is Cavitation a problem in this engine? Where can I get a repair manuel?

Bought at auction Takuchi with Kubota V3307-DI-T-E3B-TLTU1, Oil was chocolate but the machine cranked and ran fine, although I didnt run it but a minite. Other than cracked head or maybe block damage is there anywhere else to look to on this machine for the problem.? All help appreciated!

Hi to all, Have just bought used Zero turn and was going to change the blades. Have purchased blades, bolts, washers for blade change. Can anyone provide the pictures and the diagram of how the blade, washers, bolts, etc are stacked on this machine. I have looked and ahve been unable to find...

Need Blade spindle K221-72291. Cant find this part. Anybody know where to get or what will work even if not Kubota?

Will the deck spindle for a kubota RC-F20 interchange with a kubota RCK54TG ? If the whole spindle unit does not interchange will the shaft itself be the same for both decks?

What are the part numbers for Deck spindle and bearings and cup above blade that keeps out Dirt? Is there a prt number also for the complete spindle/bearing /housing assembly? All help appreciated?

What are the part numbers for Deck spindle and bearings and cup above blade that keeps out Dirt? Is there a prt number also for the complete spindle/bearing /housing assembly? All help appreciated?

Recently acquired this mower and need advice on issue of starting and motor surging along with RPM's at full throttle. The Throttle works fine mechanically however as your moving it there seems to be a sluggish response or lack of response. At full throttle the mower doesnt seem to have the...

What Steps to remove a deck from a TG1860G lawn Tractor?

Rear Idler on 1500 hour svl 95 2s gone out? is this hour range usual for replacement ? What is normal replacement time for undercarraige componets? Idler, Rollers, Rubber Track? All help appreciated.

need used idler? anybody have or where to get?

Can I install alternator myself on this machine or is it proprietary by Kubota? Does anyone know of an aftermarket that will work on this machine? kubota is a bit pricey!

Running a Kubota SVL95 - 2S. Attachment is a hydraulic driven mower with a Omni Gear hydraulic motor(model and serial pic didnt take yesterday). The Omni Hydraulic motor started a serious leak of fluid from the upper part of the motor, tried tightening the Bolts but to no avail. This motor has...

Sitting in drivers seat the Coupling on the right that runs the mower implement has started a steady drip leak. Tried to unhook and reconnect but problem still persist. It would be the high flow coupling on the right just under a small looking coupling? Could anyone give me any advice?

trying to work a SVL 95 2s; this machone has problems in that it wont start. The starter clicks as if there is a dead battery. I know for a fact the battery is not dead. Jumpiong does no good either. same clicking sound. No error codes flash. There is however the following on the diplay, at...