Search results

After working the L2850DT for a couple hours the transmission would not engage and I heard a humming noise a little bit like a 2 stroke dirt bike. It happened last time I used it a few months ago and suddenly started working after it sat a while so I changed fluid and filters then. Any thoughts?

I installed a temperature gauge on my L2850D in the top radiator hose with an inline adapter. It worked out well and was simple to install. Ran the Temp gauge cable through the fuel tank tachometer cable channel behind the instrument cluster panel. I used the top radiator hose for the best temp...

After using the L2850 with the BF500 loader bucket in float mode my transmission would not engage in forward or reverse although linkage and levers seem to be moving fine. I shut off the engine and started it back up in about an hour and the transmission engaged as normal again. My Dealer...

Anyone add an Oil pressure and Temperature gauge to the tractor? I want to add actual guages to my L275f and L2850dt so i'm curious to know where you added yours. Inline Temp gauge in top by t-stat or in the lower hose? Oil pressure sending unit in place of factory warning light or can i place...

What do you use to repair a metal fuel tank inside the exterior hidden seam? Any thoughts appreciated! Exterior Epoxy, POR15 sealer, weld (over entire seam), Brazing, Solder. ? My L2850 fuel tank has a small leak which appears to be coming from inside the bottom seam (weld) around the outside...

Looking for disconnect/reconnect instructions if anyone has a manual or label on side of the loader arm

Bought an L2850DT tractor with a bad front axle making grinding noise from front right wheel. Checked Oil in axle at front left wheel dip stick and found it empty. Heavy Oil dried on outside right front axle housing. Pulled front right "Front Axle" and both bearings and Bevel Gear look ok...