Search results

I bought a Pats Cat 2 Quick attach set for my MX5200. The directions say they are intended for lift arms from 3.25 to 4 inches. The arms on the MX are 3. However they came with shims and the .75 inch shims appear to do the trick to make them fit. So I'm not sure if I'm missing something...

I just finished the 50 hour service on my MX5200. All went well procedurally but I was a little surprised by the appearance of the HST oil and the amount of crud and metal slivers stuck to the magnet on the filter. So I'm just checking with you fine folks to see what you found when you did your...

My new MX seat switch was too sensitive. It would kill the engine just from leaning over to the right side of the tractor when I was trying to eyeball the loader. So I cut a small metal shim and installed it between the switch and the bracket. I ended up replacing the bolt with one that was...

I used a piece of cardboard to make a template and cut it out from a Home Depot door mat. I installed it upside down so as to not trap water between the mat and deck and so that it would not collect so much boot dirt. Its easier to clean that way. Fastened with body panel fasteners.

I have a new mx5200... 4hrs on it. I just bought a bush hog for that I haven’t even brought home yet. I started looking at my 3pth and tried the raise/lower lever but nothing happened. I put the lever in the down position and stood on the arms and it still wouldn’t drop. Am I missing something...

Hey everyone. I'm new the forum. I'm the proud owner of a new MX5200hst. Question... When I turn the key to the pre-start/glow plug position and wait for the glow plug light to go out, I hear a clicking sound coming from the right side of the tractor. It kind of sounds like a relay opening...