Search results

Explain about the bores. What should I be looking for as far as inspection?

The extended and compressed length should be on the sheets I sent you

Data sheets I have some pictures of the piston end/seals. I don't know what that chunky stuff is..it is hard as rock. The inside diameter of cylinder my micrometer can't reach so, I measured the spacer rings on each seal assembly. I'll send photo of cylinder inside, not great but it may be...

This loader/tractor we purchased for 1000.00. yes, a grand. The hour meter indicates 151 hours. The rest of tractor looks like it has low hours. The machine sat for years unused outside. The hydraulic fluid I drained out of it was hideous. That much invested in hydraulics still makes...

The raise cylinder on left side retracted a little more than half and air coming out of opposite fitting The right hand tilt cylinder retracted a little and air coming out of opposite fitting the left hand tilt cylinder did not retract and air out of opposite cylinder. I'm thinking this...

So that cylinder has some kind of defect, yes? I will perform this ritual on the other cylinders

For shits and giggles, in case the cylinder seals are bad, I checked with the nearby Kubota dealers. At the mention of Ansung.. "we can't get anything from Ansung". I have Ansung number in Dallas , see if they can refer a parts supplier . That's only if that is the problem. Look forward to...

First, the rod does not fully retract . It moves about halfway and stops. That is when the air comes out opposite end. You want me to cap it when it reaches its limit and cap it? See if I can pull it down/ out after capping it?

The rod retracts and air comes out of opposite end

Yes, that is what I did on each cylinder and air came out opposite fitting

All 4 cylinders have air come out opposite fitting.

Also, I tightened the caps and the loader does not bleed down .

Capped With the rod end capped off, the loader raised slowly. It lowered slowly after raising . It did not raise all the way.

I can pick up some fittings from a place in town.

I'll be digging up some kind of cap for a while:)

the loader did not raise. Fluid came out of rod end of cylinders

Yes to all those questions

There is flow into oil filler, tractor running, valve in neutral

That and my having to travel to get signal then back to perform tests . If it gets it fixed it is worth it.

Okay, I'll make it so . I apologize for frustrating you, I'll do it right this time.