Search results

That vent with the jiggler is to let any liquid out without letting trash in. If there is very much fluid coming out the vent, you have an internal seal leaking. Pertaining to hydraulic drain plugs, there are also two plugs in the rear gear housing. One on the right, one on the left just to...

Worked 25 years as the parts dept. manager at forestry equipment dealership. Great Christian people to work for. When you thought you had seen or heard it all, something else would pop up. Been retired now for 4 years and still have not found any spare time but loving every minute of it.

Does anyone know which extendable lift arms and crank type lift arm adjuster will fit the L4600. I had those on my L3130 and am really missing them. Also any source for used or aftermarket appreciated.

Question on front axle pivot for L4600 F. Replaced 1/8 pipe plug on rear hanger with grease fitting and greased. My question is about front hanger where the adjustment bolt and locknut is located. I can only guess this is to keep out slack but not sure how to lubricate. Ordered manuals from...

I also use the replacement spouts from Tractor Supply. Also, if you don't have a vent, a small hole with a golf tee pushed in works fine.

If the 3/16 is loose, John Deere dealers usually stock a 5/32 fuel hose on a bulk roll that is used in many applications to do with fuel return hoses. I had to get some of this hose for the return hoses that go from injector to injector and return excess fuel back to fuel tank on a Lister Petter...

The blue coolant that I installed in my L4600 is Rotella ELC. It is mainly for diesels in large trucks. The label on the container states it is good for 650,000 miles or 12,000 hours.

My 2013 L4600 has injection pump and mechanical injectors. It does not have a DPF. The decal at fuel cap states to use low sulfur fuel. Is this a tier 3 engine?

Just installed the blue extended life coolant in my L4600. It is my understanding that the green coolant is only a 1 year coolant.

Thanks much guys. I will probably mark them tomorrow. I have to clip about 7 acres in the next week or so and the ground is a little rough. The loader, even with bucket off does quit a bit of bouncing up and down on the rough terrain. Just cannot be very good for the loader or the tractor...

Just became an owner of a Kubota L4600 with an Ansung front end loader. There are no color codes on the hoses at the quik couplers at the joystick control valve. I am going to color code them so my question is are the colors just to not to cross hoses or are the colors standardized to specific...