Search results

I have a lot of play in my steering box, Is there anyway to adjust this? or will the steering box have to be replaced? thanks

Thanks, I will give that a try.

How do I remove the pilot bearing? It all looks good is it necessary to replace it?

If you short the starter relay on the starter to the hot wire and it starts,( BE SURE IT IS IN NEUTRAL AND BREAK ON] behind the clutch petal there are 2 or 3, 10mm bolts that will remove the cover. behind that is a multi conductor plug that gets corroded bad the starter wire goes through there...

I believe that is a standard 3/8 npt, I think that may dead end your hydraulic pump there should be a return to your hydraulic supply.

Just had same symptoms and turned out to be 3 bad glow plugs. That was on a TYM.

Got a chance today to do a little better troubleshooting, if I put a load on the tractor it would stop in all gears. My clutch petal had no play, adjusted it tractor moves in all gears now till you put a load on it.. I will be pulling it apart when the weather warms up. Anything I should look...

Probably not your main clutch. It has a hydraulic clutch that runs in fluid, it releases between gear shifts and is held in by pressure from the power steering pump, may want to check pressure from that should be around 350 lbs.. does your ps work?

Moved loader from my L2550 to the L2900, what a pain the 2900 is 1.5 inches wider and 1 1/4 in longer, thank goodness for torch and welder. works great now. now to find out why my top 4 gears on the 2550 don't work.

When I would go to the higher gears it would take 5 to 10 sec. to start to move about a week later it quit moving all together. No noise and when I changed the oil the magnetic plug had no metal or anything on it hardly any sludge. Will pull the valve body off and report back with the results...

That will be my next step, I have the sheet metal and left floor pan removed. 12 deg and 30 mph wind and it is outside will be the first of the week now till I work on it. I will check the pressure from the hydro pump first . thanks for the response

Thanks for the reply, I pulled that off the valve body (3 bolts) and moved it to the higher gears and it still does the same thing tries to go but no power. Like the clutch slipping but works in the lower gears.. ??? thanks again

I have a Kubota L2550 gst older tractor, have lost the top 4 gears, replaced the filters and hydraulic oil. Pulls good in bottom gears, power steering works good. any one have any ideas where to go now?