Search results

I need a good head for a 3 cyl D 750 engine. Ideal would be a complete upper with valves and valve cover but just the head would work.

I think my B6100E and D750 are toast. I bought this as a basket case and after a fist full of barked knuckles it ran like a sewing machine and worked like a champ. Then after it sat a while it won't crank over. It comes to a stop when cranking like it has hit something solid inside. When...

I searched the archives and I didn't find a clear answer so I'll try asking for advice. I'll get to the point. When the tractor is in gear it works like a champ. A slight growl in the tranny at times and a bit of a clunk when going from forward to reverse. However it has developed a God...

I finally have the old girl up and running again but it has a quirk in the hydro system. The 3 point comes up strong when cold and holds as long as it is left in place. To me that means the piston has no problems, as a worn piston should bleed off. This one does not. At the same time if the...

I posted last summer about the B6100E that came in a box of parts. Well after a few months of part time work it fired and ran at last. The original D650 engine had been pulled and the engine in the parts tub was a D750 which I did not realize at first until the head gasket would not fit. After...

I have a D750 B in my tractor. I had to re-assemble the engine as the head and other minor parts were off from where the owner changed engines and never finished the job. The engine cranks good and I get vapor from the exhaust. It will try to fire if I get the throttle right but it stops fireing...

As I posted before I have a B6100 tractor with an engine based on a D750. I say based on because it has a mix of parts. As I put it back together I have noticed it has no stop lever that I can find. So I have to ask before I try to start it, how do I shut it down if it starts? This is my first...

I've posted before that I'm trying to reassemble a Kubota from a pile of parts. The box of engine parts has a mix of D650 and D750 parts. I have a D750 block so I'm working that way. On the 750 just how important is the compression release for normal starting and use ? I have a valve cover...

I was "given" a B6100E that came as a "Kit". I was told that the tractor was used as a "donor" for another tractor. Supposedly the other tractor blew a head gasket and they swapped the engines. The other one was a 4X4 and this wasn't. The engine arrived in a trash can, with the block...