Search results

My Kubota B 7100 with hydrostatic transmission begins moving forward as soon as it starts without touching the forward or reverse foot pedals. Is this a clutch problem. I have no other issues with the tractor. The owner manual on page 31 shows clutch adjustment picture, Should i lengthen or...

I have a B7100 HST-D and trying to find out when it was built. Will the Model numbers or serial numbers on the tractor tell the build date? Any help will be appreciated. thanks and have a fantastic and fun day. Red Cox, Stephenville TX

I have (2) 500 gallon septic tanks with concrete risers sitting on top of the tanks for access to the clean out plugs. We have had a lot of rain and run off water is going under the risers and into the tanks. I have had the tanks pumped twice in the past (3) months. Is there a way to seal...

My B7100 HST-D has never had a real problem, however, when I started it up this morning it had a very unusual and weird sound. The sound was like a water pump going out but, of course, there is no water pump on this tractor. I immediately shut it down and looked the engine over. I could not see...

I have a B7100 HST-D in perfect condition and am considering building/having built a canopy incorporating a radiator cooling fan to help with this Texas heat. I have seen several canopies utilizing these fans on this forum. The tractor has a dynamo and I am not sure this will provide enough...

I live in Stephenville TX. This is about 65 miles South of Ft. Worth. We have 4 acres and I have a small garden where I plant potatoes, squash, tomatoes and peppers. My first year growing potatoes I hilled them by dragging soil up around the plants and had very poor results. I have lots of...

I have a B7100 HST 4WD. The pin for attaching the top link to the tractor was there when I bought the machine. There are 3 holes where the top link can be attached. My problem is this; The pin (bolt) is so long it can only be maneuvered into the middle hole and the clevis clip has a large steel...

I have a B7100 HST-D and using a Woods rotary cutter. Yesterday I removed the cutter shaft from the tractor PTO shaft to grease the U-Joints. I noticed there are (2) locking grooves on the tractor PTO shaft. One groove is about 1/2" from the rear of the PTO and another is about 1.5 inches toward...