When i jump the starter it will start. Where should i look next? Starter relay? I get a loud clicking under the dash and it puts a huge strain on my battery when i do not jump the starter
I have a L4610, does the air conditioner belt loop over the idler wheel on the right side of the engine? My belt is very loose and almost at the end of adjustment, and i noticed an idler wheel that i think the belt goes over to add tension. Thanks
I have a L4610 and when it gets below freezing my joystick freezes making it difficult to use the loader. how would I address this issue? I was thinking of drilling a small hole in each cable and heating it up with a hair dryer until water drains out. Any better idea's??
I have a L4610, the joystick in the cold is very hard to move. When I raise the bucket it keeps going and I have to force it to stop. The tractor has a cab. Does the joystick need some kind of lubricant? Does the joystick operate the valve body with cables? Thanks Mopar2ya
Sometimes when I try to start my L4610 I have to get out and shake wires near starter. I have lights on dash but does not turn over. Looks kind of tight in there to get at. Any suggestions before I start taking it apart???
My 4610 forward/reverse pedal is slow returning to neutral position. I blew linkage with compressed air to remove dirt, I used penetrating oil/grease on all fittings and tightened tension spring. It did not make much difference. Am I missing something??? thanks
I have a L4610 and am putting on a snowblower. Does anyone know the part number for the male end quick disconnect? this is so I can make hoses for the cylinder for the chute on the snowblower. Thanks
When I turn the key the pre-heat light stays on for only a couple of seconds. I have to turn my key on and off 10-20 times when cold, before it starts. Is this easy to trace the problem?
I have a L4610 with a leak coming from the rear Pto shaft. I think it may be the "o" ring behind the 4 bolt housing. Has anyone ever removed the cover and replaced the seals and o rings? Is it easy to do? THanks
L4610 I just bought this and I have a leak. Probably an ounce a day. Can I remove the hitch plate and replace gasket? Not real sure if this is where it is coming from but oil is dripping from the bolts? Is the hitch plate an inspection cover?
I am having a hard time removing my radio from the overhead panel. It is a pioneer cassette deck and I want to upgrade. I removed face plate and inserted a plastic tie strap in both sides like I have done before to release the radio from its frame...did not work. I then searched for an hour and...
For all the people with their input on me putting a cab on my L3010 problem solved I bought a L4610 with cab heat, air and stereo. It has 1000hrs on it. And I love it no more cold ass for me....hopefully. Now anyone looking for a L3010 its in Ontario and for sale
I have a 1999 L3010 with a loader, hst, how would it compare to a 2017 L3301 with a loader and hst ? I want something with a cab as the L3301 has , will the 3301 do the same job as the 3010 Thanks
I am thinking of buying a Sims cab for a 1999 L3010, the one they make has plastic side curtains. Any thoughts I want to get out of the cold. With a heater and a glass rear window it will be $6400 cdn