Search results

Thanks, Yes it does. every bit of info helps. :)

Hey everyone. finally got the loader on. Was hoping someone could tell me what pressure I should set the reilf valve on the loader control at? What psi can the pump put out? I tried out the loader with the pressure set @ 2000 hope this was not to high. I read some where on this site that too...

Hey Rex, Sorry it took so long to reply. Been away. Anyway I'll post some pic's in the next few days. With a disclaimer of course. I'm no engineer or speller. An I might break my tractor in half. (hope not) I would hate anyone following me to have trouble. I like to make my own trouble not...

hey everyone, got the loader running a month or so ago still have to fine tune it. Put in some grease fittings an comb some hoses. I was wondering what the relief valve on the loader should be set at? It came factory set at 2000. I used it this way to test it out. Then realized that this was...

Thanks much for the info! That gives me something to do this evening.David:)

I have a l1500dt and only a l175 manual. It does not include the front axle. I see a plug on top and bottom of the axle. also plugs on the bottom of the hub. I dont see a plug for full level. Do the hubs and axle share oil? how much is full? Newbee Questions I know but Can afford bad serviceing...

Thanks for the reply. I've seen one loader locally on a L1500 and it had one heay steel bracket that went to the rear axle. (when they rolled the tractor it broke the transmition case on the side without the bracket.) 700 lbs seems like plenty enough to lift a bucket of dirt. It sound like 1.5"...

Thank you for your help. The kelly loader has 2" cylinders I belive. I to am planing to make braces to transfer load to the front of the tractor. I may also make a ladder type system that runs from the rear axle to the front axle and attaches at all the hard points underneath that I can find...

Hi everyone, new to this forum. I just bought a L1500dt. I wanted to build a front end loader for it. (built a P.E. Engineering one in the past and it was a fun project) I thinking of using 2" cylinders for it but dont know if 3.7 gpm is going to be enough. Has anyone used a loader with 2"...