Search results

  1. J

    L4310e hydro electrical issue how to put in neutral

    So I'm looking at bidding on an L4310e that is really far away. They say the rear wheels are locked. Since its hydro I'm wondering if its just not put in neutral properly. They say they put a new battery in it but its doing nothing. I'm mostly concerned about getting it on the trailer with...
  2. J

    Kubota LA434 on b6200...anyone adapted?

    Has anyone ever attempted to put a Kubota LA434 on a b6200 tractor? Found a new unused(old without controls) reasonably. Was wondering if anyone has successfully adapted one to fit.
  3. J

    WTB side covers and front grill assembly for a b6200e (Gear drive not hydro)

    Looking for side covers and front grill assembly for a b6200. I'm in the Houston area but travel.
  4. J

    Purchased d950 to replace my d650 have a couple questions about sensors and coolant flow

    So my d650 does not have a water pump and the flow goes into a nipple on the lower part of the block. The d950 has a pump and it looks like it goes from the lower radiator connection to both the lower block and to the water pump. Curious if this is normal or a special situation for the mower the...
  5. J

    B6100e d650 to d950 general engine removal/replacement questions

    Does anyone have a link or some advice on doing an engine swap on a d6100e? I have located a d950 I'm supposed to pickup in a few weeks. I have done many creative engine swaps on cars, boats, trucks, and even recently an 8.1l fuel injected engine with an Allison 5 speed electronic transmission...
  6. J

    thinking about buying a bx1800 with loads of attachments and a cracked case near mid pto

    So this tractor is not in front of me but apparently reading this is semi common so I figured you guys might know the answer. It looks like the shaft came loose and hit the filter and cracked the case. Anyone experienced this? Could I buy that section of case and repair it?
  7. J

    where to put temp probe on 6100e

    The lack of water pump or temp gauge makes me nervous so I'd like to install a temperature gauge. I plan on relocating my hour meter(possibly into the tool kit hole) and then putting the temp gauge in the prominent location the hour meter was in. That said, where should I put the probe for the...
  8. J

    6100e 2wd non hydro fluids Transmission in particular Houston, tx area(not much cold weather here...)

    So I'm going to change the fluids in my new to me tractor. I want to flush the trans fluid as it looks pretty rough and I looked up on here: https://www.kubotausa.com/service-support/maintenance-schedules/lubricant-maintenance-schedule That it says utd or super utd2. I found this that shows it...
  9. J

    B6100e 2wd tire/wheel options

    I just bought a b6100e that minus a few dings is basically new(259 hours). I'm pretty sure it still has the original tires as they are falling apart(literally crumbling). They seem quite hard to find. I know people go up to 12.5 in the rear but is there another option in wheels and tires that...