Search results

My mx6000 cruise lever will not hold the pedal at speed. It just goes back to nothing. It seems like the lever has lost tension. I glanced under but it was 97 degrees out and I really didnt see how to tighten it. Anyone else ever have this issue? Its still under warranty but I hate to haul it...

I have a L3600that is experiencing significant blow by out of the PCV hose. I am pretty sure it is from ring wear and scoring. I had an air filter rip and was doing some real dusty work, so I think it sucked in some debris. Still runs good and starts up quickly. I was thinking of rebuilding at...

On my 64 hr MX6000 the alternator belt just came off. Not sure why, but it did. What a royal pain in the butt to get back on. I loosened the alternator, but it didnt give me enough slack to get it on no matter how I tried. I finally got it wedged on and bumped the starter to jump it on. With the...

I have an older L3600 tractor. This issue has been going on for a while but seems to be getting worse. If I pull the 3 pt lever all the way to lift the box blade the hydraulics will not work. The system is "pressurized". When this happens I cant control the FEL. If I push the 3pt lever down...

Just bought this tractor and its been great. I noticed a puddle of hydraulic fluid under it tonight. It looks like I bent up the hydraulic pipe and its leaking. We have been clearing some land and using the grapple to clean up and stack. I guess I took a stick up into it. Self inflicted, but...

For several weeks I have been reading everything I can about new Kubota tractors. I have a lot of kubota stuff, but I have only owned two tractors. An old L2350 then went to a L3600 a number of years ago. Its been a great tractor and we have really beat it hard. Decided I wanted a cab. I...

The time has come. I am going to add a new tractor to the stable. My old L3600 is still going strong but I am looking at a MX6000 with cab. It seems about the same size and has about 60hp compared to 39hp. Anyone else make this jump? I am going to keep the L3600 at the house and use the mx...

I recently bought a 2019 057 with 300hrs on it. Very good condition. We have used it a number of times and it has worked flawlessly. Today it started to get hot doing light work. Let it idle and it cools down but not all the way. Rad is clean, belt is good. Fan is pulling lots of air through...

Recently brought my L3600 into the shop to fix the leaking steering cylinder. I noticed the rear axle was was dripping on the shop floor. Cleaned it up and it appears to be coming from the case seal. I pulled it apart tonight. It isnt very hard to remove. Basically remove half of the ROPs...