Search results

Does a jd model 70 fit an L2850? I can't seem to find Any dimensions on the mount for it. There is one comming Up for auction. If it is anywhere close to fitting I think I I think I will try to pick it up Jason

While bush hogging the other day my L2850 started popping out of Low gear. It is really annoying having to stop and put it back in low. I split the tractor to change the main seal on the tranny last year. I Didn't make any adjustments to any of the gears in side. I did adjust the Clutch. Has...

I can't seem to get the clutch adjusted on my 2850. In order to get the pto to shut off the throw out bearing is always spinning. When I put the new clutch discs in and pressure plates I couldn't find a way to accurately adjust the bolts that contact the bearing. I Left it where it was when I...

Just when I thought this would be easy she threw a curveball and nailed me in the noggin. I started to take the l2850 apart again to split for oring replacement. When I drained the hydraulic fluid I found some metal chunks in it. They are pretty large steel parts. It looks like the corners of...

Well I just got done getting the l2850 back together after replacing lots of stuff. New clutch, throw out bearing, pilot bearing, rear main seal, input shaft seal, pto shaft seal etc. she ran good with no leaks for about an hour around the farm. Went out to put on the spreader and saw a puddle...

I just got the tractor back together after splitting for clutch replacement. I have put most of 10 gallons of UDT in and still can't see any fluid in the sight gauge. I have fluid coming out a hole on the left side of the trans where the brace for the fenders is. I tried to get a picture but...

Well the ol girl has developed a hydraulic oil leak out the front of the trans. I got it split with out dropping it on my toes. I got the front housing pulled and found an oring where the housing mates up to the transmission. It is mentioned in the service manual to put it in but it is not in...

Well I took the tractor out for a while and thought I would try out the pto. When I pushed in the clutch and engaged the pto it started spinning right away. Inwas wondering if this is normal or if I need to adjust the clutch? All of the other tractors I have run the pto dis engages with the...

I just bought a new to me l2850. When the engine is running the Tach is below 0. When I rev it up to about max it reads 500 rpm. Is there a way to fix the tach or just replace it ? The cable is intact on both ends. It seems a bit short to me. Jason