Search results

Well after separating the steering arm from the rod and unbolting the steering column gearbox from the trans housing and removing the the injection pump stop cable I was able to move everything around enough to get the 2 pesky nuts off. Then I was able to remove the whole steering assembly...

Hey Dusty...I think we are talking about the same bolts...Gary

Some discussion on other sites I frequent most popular right now is a 50/50 mix of acetone and dextron3

Thanks Vic...throttle is disconnected now. Looks lke the panel is also attached to the steering column and the bolts look next to impossible to get at! I don't want to break anything!...Gary

Where is the best location to disconnect the throttle linkage?

Can I run Carlisle true power 31x15.5-15's with 13 " wide rims on my machine this is for a grass cutter,the parts manual shows 31x13.5-15 were available. Turfs would be prefered but there is a deal on this size. Also what should I put on the fronts. There are 16" ag tires and wheels on it now...

Thanks Dusty! I will look for them. There are a number of panel lights that don't work. It will take a while to figure all that out!

Hi... in order to remove my steering box it would seem the dash panel needs to be removed. This is not covered in the service manual and the parts manual is not very helpful either, Does anyone have any insights or experience? So far I have removed 2 bolts at the bottom of the dash(facing up)...

Thanks Vic it looks like the turfs require a 10" wide rim. Is the offset and bolt pattern correct for the B7200 also looking for front rims for the 4 wheel drive version..Gary

Hi I am trying to locate a set turf rims for my B7200 rears are 15 inch x 12inch? wide with a serious offset. Is there an aftermarket source for these rims or are we only able to get them from a Kubota dealer? Does anyone have any experiences in this area?

Hi all!.. hope that it's ok to post in this forum for a wanted item. I now own a B7200 4WD gear trans ag tire tractor. I would like to buy a used service manual from someone who has a spare or has sold their machine. New is a bit pricey! Also looking for an operators service manual for the...

Thanks Dusty...I guess the hydros must have some type of independent PTO so that you don't have to clutch to engage the rear PTO. 2 of my MF's have dual clutch which works the way you say. I don't think this b7200 is for me...Gary

Hi and thanks for taking the time to read my question(s) I may have the opportunity to purchase a B7200 4wheel drive CUT it is not the hydrostatic model. It has a belly mower (60") that is non Kubota. I think it was a continental. It runs off a 180 degree shaft from the PTO to a gear box in the...