Search results

Just got my tooth bar from BXpanded. So far do good, After reading all of the posts about various body parts snagged on Piranhas, I decided to make a safety guard as a preemptive measure. Since I tend to keep bits & pieces around, I had a short section of corrugated drain tile lying around...

I'll start with the information I got from my dealer and the state service rep along with my NEW operating instructions and then give you my backstory. The B3350 does not have common rail or electronic fuel injection - it has mechanical fuel injection paired with electronics that "monitor" the...

Hi - Welcome to OTT! Sounds like you're already getting a lot of stuff done with your new machine. Don't know if your machine has gone into parked regen mode yet or not, but I learned that it won't do a parked regen if you're low on fuel - don't recall that it was mentioned in the owner's...

Block heater highly recommended ASAP. I've got a couple of fields that get so soggy the only time I can do my annual bushhogging of them (without sinking to the axles) is in zero or lower temperature. Last year I couldn't get it started in zero weather - glow plugs were clicking, but it...

Great job!

Thanks for sharing this. I always have my implements on the ground before detaching, but didn't think about the FEL frame dropping - always good to keep feet (and other appendages) clear. Glad you're healing! We've got to work safe so we can enjoy orange tractor fun.

Finally getting around to weed-wacking 4 rows of pines along our road frontage. Am also marking all of the stumps (from culls) that I invariably hit with the MMM. Hopefully, I'll grind them all out before the first snowfall.

Welcome to OTT! Go with your gut. My enabler (spouse) got tired of me complaining about a green machine that would break down as far as possible from the house (at most inconvenient times/weather). She was right - haven't been disappointed and when I need service or have an issue, my...

I started out needing an aerial work platform to clean up & trim a LOT of white pines along our road frontage. Since I was working solo, I needed my AWP to be fully loaded with everything that i'd need - so it evolved into an AWP/carry-all - here's my post with photos -...

Hi - I'm coming in late to this thread, but I've got the King Kutter XB Dump trailer and am using it with my B3350. Before I got the 3350, I had the trailer and was using it with a garden tractor and the manual pump. When I got the 3350, I had the dealer install a (single) rear remote to use...

LINCH PINS - MIA

Great info - I need to "harden" exposed failure points on my B3350. Seems like if there's one, I've got brush, bramble or a limb that will find it. Maybe I need to armor the undercarriage ...

Hi - I was trying to figure out the best solution for getting power in the field - I've already got the plug-in tools - i.e. hedge trimmer, angle grinder and not interested in buying a second set that use batteries. Read threads about PTO gensets and also about inverters. Decided to just put...

Thanks for the tape idea. Haven't used it in wet conditions yet, but a roll of non-skid tape sounds like a good investment in self-preservation!

Just put together my carryall/fork aerial work platform for my Kubota B3350 - version 1.0. I needed a stable work platform that would get me 7' - 8' in the air to clean up a lot of pine trees (safely), I wanted to have an organized work area when I'm in the air and after looking at the great...