Search results

Good deal........I'm happy for you. :)

This. Repair and adjust.

Yeah I'm aware of it and I asked the dealers round here..........eyes roll and shoulders shrug. I make my own path anyhow.

Yes, use anti-seize. And three years from now when he has to take it apart again he won't have to go though this again. BTW, heat will destroy the seal and beating on it when a BFH ain't doing the seal and bearings any favors. And dont' confuse a roll pin with a tension pin.

http://www.stevenstractor.com/parts/compacts/kubota/b-series/front-or-rear-wheel-rim.html Similar to above for rear but found locally. The 12" wheel was sourced at Everything Carts in Jacksonville FL, I called yesterday and they are now discontinued and they took down the link today. I am now...

Don't discard that exhaust elbow.....you can fit a new can for $30.

I can replace a lot of zerks for $50+ .......read the reviews.

Yeah thanks. I've been through all the threads here.......I used his equation to figure the ratios.....very helpful. But I don't have turfs now, not a matter of tires that fit turf wheels.

Tire and wheel options for the 7100.....DONE!!!!!!!!!! I'm going after these for the rear, 9.5 16 Titan Dura Torq. All the 9.5 16s that I have found on the net have a stated retail of nearly $600.......gotta see what my local retailer can do for price. Found a 8x16 wheel for the front of a...

Try to get an accurate measurement of yoke center to center before you or someone else takes it completely apart incase you have to have a new weld-up shaft made. Also note the yokes relative to each other on the shaft so not to be 'out of phase'.....if so they will fight each other end to end...

Can you post some pics of your damaged shaft? As for the shaft itself.....nothin more than round stock and two yokes. Driveline shop here could have the shaft and yokes trued up and welded for less than $150. This leaves the splined yoke at the trans......what's that cost? This ain't $600...

Also... Drill the center out of the roll pin first. Then use a puch to drive out the remnant of the pin. Then drill out for the larger roll pin.....do not try to drill the larger hole all in one shot....drill will wander off.......trust me. You may find that once you remove the sheared pin...

Roll pins are a common item........NAPA........Fastenal......etc. Use matching drill bit. Roll pins are hardened.......cotter pins are not sufficient. There are specific punches for roll pins......very important to get a set.

Thanks. No, I'm looking for something else.........been all over the net and nothing posted. I'll have to have them custom match. If anyone one is interested I'll get the formula and post here. I'll probably buy a the rattle crap in both blue and orange from the dealer and use it to make...

I need a formula or Limco or other paint code. I went to our local paint store to get the Kabota blue and they don't have a formula for it. I use automotive grade acrylics. I also need the early orange too. Thanks Scott

Have you got any pics? any more info? I would also be interested in a tach for mine. Thanks

I just graduated from Cub Cadet to something that does some real work. :) Picked it up last week and finally got some time to do some work on it today, maintanance was not a vocation with the previous owner. I came with a 4' LMC finish mower and I already had a 5' rake and 4' box. The...