Search results

Ty, I actually have the wsm manual, but it assumes the read has some Tractor knowledge. I don't have much...lol

Thank you.

Thanks to all of you, I really appreciate it. I checked the external parts a couple of days ago and all seemed to be functioning. The roll-pin #150 is in-place. Looking at the diagram of the Feed Back Lever I think I understand how it function, but would like to verify. I see the device as a...

I tested with the speed control fully open, video below. The length I am having to move the raise the Position Control does seem further than it did a couple of months ago. I only have a few acres so it doesn't get used much, maybe a 100 hrs a year.

I tested and the link is below. With the speed control open, raising the 3pt, it will not hold its position and shakes. https://photos.app.goo.gl/uzwqk3c7jkKWQndv6 Jerry

1st Time Up - Open the Lowering Speed Control Valve - 1/4 Stops and Holds position w/o Shaking - same for all the others. * The 3pt will not lower via the Position Control. I have to Open the Speed Control Valve. I opened until it dropped very slowly with the Position Control Level in the full...

The external parts of the linkage are moving as the 3pt lifts and lowers. But, internal to the Control Valve I have no idea what's "moving" there. I will take a look at the diagram of the valve.

No Draft Control. Acted the same across the adjustment range.

Here is a video of the Test with speed closed and lifting 3pt. Opened speed valve, 3 pt bouncing and video of feed back linkage.... https://photos.app.goo.gl/yETgDVXYQqUf7DmV7

I did that from min to max with stoping and testing along the way.

As I mentioned in another reply, I do not "hear" a change where it releases no matter where I move the adjustment. Also, I have about 50 threads of adjustment space. Since I couldn't hear a change I moved it about 10 threads and tried it again with no difference. I will perform the following...

Answers: 1) Yes it worked for a couple of years. I do not recall it laboring as much. 2) Yes, it did stay up, but with much less bounce. 3) I will do the test in the morning as suggested an Post the video.

I lowered the arms, closed the speed valve, raised the lift, shudders at the top. Continues to shudder until I lowered the lift. I created a short video here is a link (looks like you need to copy and paste) . https://photos.app.goo.gl/EiZz7dPyB4SCg3eu6 Once again, I do appreciate your time...

I've attached a copy of the Hydraulic Circuit. I assume the FEEDBACK circuit is the UPPER part of ITEM 6. I can make the problem stop by CLOSING the LOWERING Valve ITEM 7, which I assume stops the flow to ITEM 8, the LIFTING CYLINDER.

It happens at any height of lift. All the way down, no problem. I read the manual and the advice earlier in this thread of adjusting the feedback linkage. The problem is, I never hear a "release" in pressure. It makes me think that the release valve is not working correctly??? Is that possible...

I finally had a chance to find a manual and understand what I was adjusting. With tractor running, I lift the ARMS, they raise to highest point and they begin to bounce and shake. I do not hear anything "change" like a valve opening and releasing pressure. Then the bouncing begin and...

I've looked at the WSM that I have and cannot locate a Feed Back Rod Adjustment. The feed-back rod is only mentioned in the the Description of how the Controls work on page 9-13.

No "second" lever.

Yes, I do have a PDF copy. I'll use it for the feed-back adjustment(s). Give me a few days to get back to it.