Search results

The end of the cylinder hose is larger than the end of the short hose that connected to control valve

That is the end of the hose from the hydraulic cylinder both are the same

I ran into a problem I can connect the hoses I guess I will have to get some kind of connector to do that test.

It didn’t come with the PB plug I can buy it separate didn’t think I needed it but I might need it after all.

Ok plumbing is correct. Next step?

yeah it It has me confused and to add to the confusion I can raise my boom if I slightly pull back on my 3ph lever and pull my boom lever at the same time and if I let go of my 3ph lever while holding the boom lever back it will fall to the ground

My plumbing is exactly as your diagram shows checked 3 times

I don’t know but when I tilt the bucket all the way back and return to neutral it falls back down or in other words the rod goes out extends on its own

Ok this is what it’s doing it will tilt and dump the bucket but when you return to neutral it falls and the boom will move about 1 inch each direction and that’s it and that’s with 3/4 throttle

Ok yes I have traced it 3 times and it is exactly as your diagram. My only question is the T does the line from the second port on the hydraulic block go to the T port?

On hydraulic block the first hole next to the pump is the pressure and it goes to the left side of control? But the second hole on hydraulic block goes where? To the back to tank on the right side or do I have to run a return line back to the transmission fill hole? Thanks for your patience I...

W Where do you have you 2 port from hydraulic block going to? Do you have your T port from control going to fill port on transmission? My tractor is just like yours it’s a b7100 manual transmission

It does not pick the front wheels off the ground. It picks the lift arms up and when I curl the bucket back the lift arms hold their height. The loader is a bison vh350. From the hydraulic block there are 2 ports the first port on the hydraulic pump side the one towards the radiator I have the...

Yes it will pick up the loader and when I curl it back and let the lever back to neutral it doesn’t hold and will tilt forward and dump

It has down pressure when I dump the bucket but the lift cylinders do not hold and it picks the loader up and when I curl the bucket back the loader will be picked up off the ground but then the bucket will uncurl on it’s on like it has air in it maybe?

No I do not have a test gauge my blade worked correctly when it was on there up and down side to side. But that is the right control for that tractor?

https://summit-hydraulics.com/wp-content/uploads/2017/11/P401-2A1-Left.jpg That is my control