L3130 GST Intellipanel

[Eikermann]

I’m looking for some help, I bought this tracker as a project and not running. It was missing a few items like the radiator and a few other, the previous owner told me that he bought a tally panel for it trying to get it running. I have been troubleshooting and troubleshooting trying to figure out what is going on, but after looking very closely at some photos online, I really think that I have the wrong intellipanel and I was hoping somebody could confirm this I think he bought one for the 40 series instead of the 30. So I think that is my problem. I do know they have different part numbers even though they look very identical. Here are some pictures of it. I’m hoping somebody can confirm this for me before I spend $1300 on one lol

 

[whitetiger]

Here is the dash from an L3130 as shown in the operator's manual. It is significantly different.

 

[Eikermann]

Yeah I been looking at and comparing pics online and I’m pretty sure this Intellipanel is for the L40 series

 

[ferguson]

Panel dose not like mine on my L3130

 

[Eikermann]

Well here we go fingers crossed. Like I said, I bought the tractor and it came with that panel on it and was not running. They look so similar that it took me a while to figure it out. I have been going through the wiring, looking for shorts and everything so I really really hope this. $1401 Intellipanel is the cure to my problems lol

 

[North Idaho Wolfman]

View attachment 171202 Well here we go fingers crossed. Like I said, I bought the tractor and it came with that panel on it and was not running. They look so similar that it took me a while to figure it out. I have been going through the wiring, looking for shorts and everything so I really really hope this. $1401 Intellipanel is the cure to my problems lol

It's very very unlikely that the panel is the reason the tractor won't start and run.

Might want to start another thread on that issue.

 

[Eikermann]

Please don’t tell me that, looking at the pin out for the connectors that plug into the Intel panel. The connectors are identical, but it seemed like the termination points for the wires were different so I think that’s why I was blowing the fuse

 

[Eikermann]

Gauge cluster seems to have fixed my electrical issue