Svl95-2s injection pump gear teeth angled wrong way.

[rabtech]

I was finally able to get the picture of the valve cover sticker.

 

[rabtech]

I dont see anything in that label that helps. It looks like they just put the cover of the original engine on it. Which doesnt help at all.

 

[ruger1980]

This is the configuration I have in my V3800 manual, But I suspect is may be a newer variant. You are best served by contacting your Kubota industrial dealer to verify what should be in that engine.

 

[ruger1980]

Also get the stamped sn off the LF side of the block where @whitetiger indicated to get the correct engine sn.

That is as long as no one has messed around and swapped things.

 

[rabtech]

Here is a picture of the side of the block. Im guessing the digit after the T is 8. But that is a total guess.

 

[DrankTheOrangeKoolaid]

If you have room to reach in with a piece of paper and a pencil, I've had success with that old trick when I couldn't get a decent picture.

 

[rabtech]

I have decoded the number. But it still does not help.

Its a 2 that is faded.

So the number is V3800 - T - 2FW0187

This breaks down as 2 = V3 F=2015 W=November and 0187 = a sequence number.

How do I order parts from that number ??

 

[rabtech]

Ok. So even Kabota has no idea what engine this is. But nevermind that. I have made some changes and I have fixed the original issue that caused all this mess. I just need to know if I have this these gears in time. Im 99% sure I do.

 

[North Idaho Wolfman]

It is quite the oddity, I looked in every book and online source I have available, and no one lists those gears any differently.

I don't like the way 1 and 4 line up, but it might just be the camera angle.
besides that, yes they should be in time.

I take it your going to run it with the busted up gears?
It would be wiser to change all the gears to a standard set, I posted a link that set and they were pretty reasonable.