Kubota 2005 RTV 900 hydraulic lines
- Thread starter cwb337
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
You can see illustrated parts lists and diagrams here
apps.kubotausa.com
There are a lot of different RTV900s listed so you may need to get the complete model number off the sticker on your vehicle.
Kubota Tractor Corporation - Illustrated Parts List
- K-PAD - Parts Lists - Illustrated Parts Lists - diagrams
There are a lot of different RTV900s listed so you may need to get the complete model number off the sticker on your vehicle.
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA
Do you have to unplug the bed tilt cylinder to plug in the hoses to the blade?
Does your bladehave only a raise/lower function, or does it also have a hydraulic angle adjustment?
Yes, you do have to unplug the dump.bed to run the power angle blade. The up down works on an electric pump.
You can see illustrated parts lists and diagrams here
Kubota Tractor Corporation - Illustrated Parts List
- K-PAD - Parts Lists - Illustrated Parts Lists - diagrams
There are a lot of different RTV900s listed so you may need to get the complete model number off the sticker on your vehicle.
Attachments
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA
You will not find anything with the blade in the RTV 900 parts, as the blade will have its own model number.
That crossed my mind. But the manner in which these lines are installed matches everything else from the factory. At the very least, this would have to be a dealer-installed option. These lines go from the rear remotes (the same ones the dump bed uses) and are controlled by the same lever /valve that works the dump bed.