Recent content by willierivers

I purchased a syphon and pulled the fuel out and then ran it back in through a screen. Didn't see anything. Hopefully I broke it up enough to pass through to the fuel filters. Ran good for two hours after I blew out the line. Will wait and see if it returns before I even think about pulling the...

Checked the flow and it was weak, know the feeling sometimes, I blew it back towards the field tank and now it has a good flow, just like my younger years. I'm going to try and syphon the fuel out and maybe pick up the trash. Been reading that removing the tank is a real pain. Thanks again.

Have a 2013 BX2370. I have changed the fuel pump and the fuel filters and after about 30 minutes in starts to stall. It was doing this before I changed the filters and pump. At a loss as what could possibly be causing this. Thanks in advance.

Looking for a parts diagram to assist me in cleaning out my M9960 Water separator assembly. Not just emptying out the bowl. My tractor dies after a short time running and the water separator bowl has a large air gap. Tried bleeding the fuel system as per the service manual and continue having...

After replacing the fuse from my issue with error 25 coming up, I have noticed my speed is not registering on the dash. Stays at 0.00 mph on the display. I have checked the fuses and all are fine. Anyone experience this issue? Thanks in advance. Sent from my XT1585 using Tapatalk

Thanks "mbu" for your suggestion. If you are ever in Caldwell, Texas let me know and supper is on me. All still good with the tractor.

Thanks to sheepfarmer's suggestion, I checked the fuses today and a five amp fuse identified as "T/M Control 5A" was blown. I replaced the fuse and all is right in my world at the moment. Just waiting to see if the tractor goes into regeneration mode without blowing the fuse. Sure would like...

Just heard back from the dealer, said it involved the Regeneration system. They said they needed to get a computer hooked up to it to verify. I'll check the fuses as you suggested and maybe that's the problem. Just past my 2 year warranty so any repairs maybe on me. Tractor has less than 150...

While using my M9960 with a grapple attachment, error code 25 appeared along with the red triangle safety symbol. The tractor would not move while in gear. After moving the speed lever from high to low and back to high the tractor started moving again. I immediately parked the tractor and...