Recent content by Torrin

I know the feeling, my "honey do" list is novel length.

Does anyone know of a good set of rear spacers for my tractor? I have a BX2680 with a Curtis cab, and it is very tippy. The tires are loaded (beet juice).

The manual online showed that I needed to check the brake fluid. I will do that. I appreciate the responses. except for the person who needed to be an ass. for that person, I am preparing a bed in the Ionia Hospital for the criminally insane,

The light is the I in a circle

I recently bought a 2013 RTV1100C and since I started repairing some rust, When I start it and let it run, the light on the dash stays on. My manual is lost, does anyone have any idea what the light means?

I have not had front tire chains on my b2650hsdc for several years. Last year I almost went over the edge of a hill because my snowblower would slide and my turf tires would not grip. I ordered Grizzly chains for the front that were supposed fit from 23 to 24.5 x 8. They don't. I added a 3 link...

Thanks for all the replies. I will have put the mower in the barn and tip it up to check the blade(s)

Good Afternoon I have an interesting and expensive problem. When i engage my rear pto with a 52" brush mower on it the mower deck and the tractor just slams hard enough to raise the deck off the ground. Is that normal, and if not how do I fix it? I made the mistake of engaging the PTO when I...

I now have a 2650 with a LA534 loader. Does anyone know the correct size for the loader that I have? I get two different measurements. Without the reinforcing plate in the loer corner of the loader it is 58-1/2 with the reinforcing plates it is 58- /8 My Piranha that I had on my BX did all I...

I know that you fixed your problem, but I believe it was unnecessary. i have had 2 different BX models. I had the same problem, but all I had to do was raise and lower the MMM and put it back in the High position. Knob turned it fine. Book says that adjustment must be made with MMM at top of...

Good afternoon from the snowy north. I am selling my BX2230 and part of the package is a complete set of chains. I recieved a note in my e-mail form someone claiming that front chains will cause excessive wear on the front clutches. Any truth to that? I ask because the chains came from the...

I may be just an old mailman, but I would like someone to explain to me how making payments that amount to more then the cash price is 0% interest. Last time I looked if I bought something on term for 50 dollars it would only be 0% if my total payments came to 50 dollars:rolleyes:

Thanks Hokie That is what I needed. Now I can get a good radio

Good morning; now that the inevitable happened and the Lions got their butts kicked, I need a schematic of the radio plug in for the B2650HSDC Headliner. I have pulled the radio slot cover and have the white nine pin male plug and the antenna plug accessible. I found on EBay a female plug to...

Thanks Cleo; I am afraid that the box you made will not work. My B2650 is the factory cab model. I saw one that went into the loader post., but that one was too small. My father-in-law made a wooden one that went on his back blade, but it is falling apart. I have an extra 3 point (from a...