torch's latest activity
-
torch replied to the thread B7100 Piston Installation.FWIW: The B7100 WSM says crank it with the starter at 200 to 250rpm for 5 to 10 seconds. That's a range of 8 to 21 compression strokes... -
torch replied to the thread B7100 Piston Installation.Don't mistake volume for pressure. Pressure only increases when volume is restricted and the discharge can be calculated by Q=K(P^-2)...
-
torch replied to the thread B7100 Piston Installation.There are Schrader valves and then there are Schrader valves. Well, different valve cores anyway. Compression testers should be fitted...
-
torch replied to the thread B7800 front axle ball bearing question.I was being facetious. The right bearing was a sliding fit but the left bearing is smaller.
-
torch replied to the thread B7800 front axle ball bearing question.So far in this thread: B7200: not press fit. L3901: press fit B7800: one of each.
-
torch replied to the thread B7800 front axle ball bearing question.I thought he was referring to the bearing at the bottom of "G120XX": Which is not to say it couldn't be a press fit too, but looking...
-
torch replied to the thread Front loader for a B7200.I may be a bit late to the party here, but I used 1" dom tube for the bushings and 1" cold-rolled for the pins. Before cutting the pins...
-
torch replied to the thread B7800 front axle ball bearing question.You are not wrong in anything you have said. But Kubota USA may be the one sourcing the replacement parts. And if some bean-counter...
-
torch replied to the thread B7200 FEL to mini skidsteer quick attach modification.I'm not trying to convince you one way or the other. That said, the SSQA standard is about 44" wide (32-3/8" CtC pin spacing) x 16"...
-
torch replied to the thread B7800 front axle ball bearing question.I'm not saying it is counterfeit, just looking for a possible explanation. NSK is one of the top bearing manufacturers in the world --...
-
torch replied to the thread B7200 FEL to mini skidsteer quick attach modification.I think you are overestimating the thickness of a SSQA system. There's not much difference unless you are putting an adapter on a pin-on...
-
torch replied to the thread B7800 front axle ball bearing question.That is, ummm, unexpected ! I wonder if you ended up with a counterfeit NSK. Apparently counterfeit bearings are a thing and...
-
torch replied to the thread Hydraulics help : no pressure high rpm - normal at idle.If your loader has a PB port then that should be the one that goes back to the 3ph (and other functions). There should be a separate...
-
torch replied to the thread Exhaust modification.No question: one cannot tell how heavy something is from a photo. Hopefully the reduction in weight is sufficient to offset the...
-
torch replied to the thread Exhaust modification.Really? Wow. The B7100 exhaust could be mounted horizontal or vertical, but it has an extra support for horizontal mounting. Vertically...