Recent content by ThomasXZ

Yes, that is what I found during my first bit of troubleshooting is that the K-Connect can freely move forward and backward off the machine not hooked up to the snow blower and then once hooked up to the snowblower it does not properly align and seat it all the way in. I'm quite a bit...

Please see video that I postage from a different reply. The kind of explains it. I'm assuming that inner male and of that spline collar is hitting somewhere in the female and at least that's what I was able to find when I put grease on the male end. I did take a die grinder and grind out a...

Yes sir. That was the first thing I tried.

Here are some more photos for you. Not sure how to fill size them. And yes I am positive I am using the correct driveshaft. Here is a Video that kind of explains it also

This is as far as I can get everything to line up. It will not seat in all the way like it should

Correct.just the k connect coupling isn't seating all the way into the blower shaft. Here are photos. Co

Hello, I have a lx2610 and I can't get my k connect system to line up. I took the shaft off and they fit in just fine. So I know something is either tweaked. Bent or worn out. I am curious if others have this issue because I have only used it two winters. Only have 140 hours on my machine...

I bought a shop service manual too. Just didn't arrive till today. The flow stayed the same, as mine are not adjustable. Just some metal shavings. I am gonna take apart the pump or cylinder to see if there was somehow any real damage. [although with the flow.... if fluid is going in... not...

Fixed: Somehow material was in one of the flow restrictors... All good now 🤟🤟

From my glance at them. They just looked like a fitting that screws in to the pump/ cylinder.

I have not yet. I figured. Because (fluid was shooting out of both of them) it wouldn't make a difference.

I do I do not believe mine has thoses, I just have one like the photo above LX2980 snowmblower. Still away, probably wont be home till monday .

the only thing i did not do was remove item 6, and blow compressed air in. I did look in there with my trusty eyeball and did not see anything "plugging" the hole.

Correct it spins with manual hand power with the hoses disconnected. It will shoot the fluid out each way when I turn it. I can hook it back up. Have it spin one way then back other way slightly. Then locked up. Won't spin left or right. I am away from home so I can't take photos till Sunday...

Correct. It is not jammed or anything I took the gear off as well to see if the issue would be resolved. Negative. Can rotate one way once I release a line to relieve pressure in the system. But once pressure in the system cant go left or right. It is stuck.