TheOldHokie's latest activity
-
TheOldHokie reacted to North Idaho Wolfman's post in the thread L2600DT Rabbit Netural Turtle Shifter with
Like.
The spring #70 and the ball #60 are in a pocket in the shift fork (yellow) that when #20 shaft is inserted inside the shift fork the... -
TheOldHokie replied to the thread oil for MX6000.Interesting list. I have never seen those specifications in any USA publication. In the USA its strictly SUDT2 and UDT. There are many...
-
TheOldHokie replied to the thread B7200 Lots of lost movement in the TPH position control lever.Thsts not the way its suposed to work. Its also not uncommon. The valve and/or linkage is worn out and needs to be serviced. Dan
-
TheOldHokie replied to the thread BH77 sub frame kit help?.YouTube videos are way too often long miserable productions that could be condensed to 1/10 the length without any loss of the content...
-
TheOldHokie replied to the thread bucket tilt.You need to do some simple testing to find the source of the problem. If the cylinders were opposed they would not work when switched...
-
TheOldHokie replied to the thread L2600DT Rabbit Netural Turtle Shifter.No hands on knowledge but it Looks like a shift rail detent to me. They are often assembled by placing the ball and spring in the rail...
-
TheOldHokie replied to the thread BH77 sub frame kit help?.Assembly, owner, and work shop manuals can be downloaded from Kubotabooks.com Dan
-
TheOldHokie replied to the thread bucket tilt.Yes but your problem is not the valve. Dan
-
TheOldHokie replied to the thread Blade lower on one side.I have fixed more than one bent deck flange with a 2x4 for a straight edge, BFH, and a handful of ring shims. What do you propose to do...
-
TheOldHokie replied to the thread Blade lower on one side.Shims my friend, shims. Dan
-
TheOldHokie replied to the thread Blade lower on one side.Spindle is new so I think its safe to assume its straight. Ths outside tip is running low, what about the inside? That spindle...
-
TheOldHokie replied to the thread Blade lower on one side.Bent deck.
-
TheOldHokie replied to the thread Blade lower on one side.This aint rocket science.Turn the deck over and lay a straight edge across it sides to side. Rotate each blade until its parallel with...
-
TheOldHokie replied to the thread Blade lower on one side.I think Sawdust and Shavings is reading my mind 😀
-
TheOldHokie replied to the thread Question on a Kubota B2400 Loader Valve.Confirmed the 3pt lift works fine when LA525 boom is in float. Pretty easy to see what your valve is doing. Just disconnect the PB hose...