TheOldHokie's latest activity
-
TheOldHokie replied to the thread Front loader for a B7200.I just realized I misspoke - the B1630 cylinders were 1.5" bore. Dab -
TheOldHokie replied to the thread Kubota UDT2 viscosity rating and has anyone used it in another oem zero turn?.Looks like Permatran 821XL which is a very conventional (J20C) UTTO. It has a KV100 of 9.5 cSt and viscosity index is 140. SUDT2 is a...
-
TheOldHokie replied to the thread Front loader for a B7200.The B1630 was minimalistic. Here is a bottom bracket and pin. No bushings. No bolts. Just a 3/4" pin snd welded tab with one edge bent...
-
-
TheOldHokie reacted to Daren Todd's post in the thread Kubota UDT2 viscosity rating and has anyone used it in another oem zero turn? with
Like.
Check what the manual says for the gravely transaxles. I was thinking along similar lines when I got my kubota zero turn. Then started... -
TheOldHokie replied to the thread Kubota UDT2 viscosity rating and has anyone used it in another oem zero turn?.What model Massey and what is the recommended oil? Dan
-
TheOldHokie replied to the thread Kubota UDT2 viscosity rating and has anyone used it in another oem zero turn?.SUDT2 is a Universal Tractor Transmission Oil (UTTO) formulated for use in hydraulic systems, transmissions, final drives. axles...
-
TheOldHokie replied to the thread Front loader for a B7200.The B1630 had zerks on the cylinder eyes and ordinary 3/4" steel pins with a locking tab to orevent them from rotating. There were no...
-
TheOldHokie replied to the thread Hydraulic Controller.May I ask why you are replacing it? Dan
-
TheOldHokie replied to the thread Hydraulic Controller.The sleeve goes in the N (neutral) port and separates tank return flow from the neutral power beyond flow. Probably beyond your current...
-
TheOldHokie replied to the thread LA480 - Boom Cylinder troubles.I did not miss the comment but I think you missed this one The LA482 manual is clesr 45mm (1.77] x 450mm (17.7). That would be a 1-3/4...
-
TheOldHokie replied to the thread LA480 - Boom Cylinder troubles.Have you confirmed the width at the pins will fit inside the loader mounts? Dan
-
TheOldHokie replied to the thread LA480 - Boom Cylinder troubles.The LA482 manual is clesr 45mm (1.77] x 450mm (17.7). That would be a 1-3/4 x 18 cylinder.. A 20" stroke is going to be way too long...
-
TheOldHokie replied to the thread LA480 - Boom Cylinder troubles.Kubota prices are absurd snd one inch in length is not likely to be meaningful. But you need to be sure of your measurements and you...
-
TheOldHokie replied to the thread LA480 - Boom Cylinder troubles.The threads on that cylinder are TOAST and will never be reliable. As best I can tell the Kubota cylinderl has SAE-06 ports just like...
-
TheOldHokie replied to the thread LA480 - Boom Cylinder troubles.I would measure bore, stroke, retracted length and go shopping for two new cylinders. They dont have to be an exact match. Here is one...
