TheOldHokie's latest activity
-
TheOldHokie replied to the thread Normal for relief valves to stick?.Its not normal. Which boom and which relief valve - pump, loader or BH? Dan -
TheOldHokie replied to the thread Kubota Advice: Buy and Fix up L5030HST, or Get Newer TYM?.Then go find one. Dan
-
TheOldHokie replied to the thread Kubota Advice: Buy and Fix up L5030HST, or Get Newer TYM?.I will put this real simply - you are living in the past and have an unrealistic budget based on your stated needs. In 20 years a 20...
-
My MX4800 just did the same thing. After looking into the slit where the throttle lever goes I put my finger in there and moved a little...
-
TheOldHokie replied to the thread Help!.Backhoe mount?? Dan
-
TheOldHokie replied to the thread L2850/BF500 Pressure test question.Thats a poor test point and setup because it is presenting you with confusing results that you cant interperet. Do not proceed with...
-
TheOldHokie reacted to North Idaho Wolfman's post in the thread Hydraulic Fitting questions with
Like.
OK hear ya on loader relief valve location, I get that. I can tell which valve he has by the detents. It's a 4 position valve. -
TheOldHokie replied to the thread Land Pride SGC0554 Claw Grapple Grinding Noise??.Can you run a drill press? HINT, HINT... Dan
-
TheOldHokie replied to the thread Land Pride SGC0554 Claw Grapple Grinding Noise??.Might be nessy but I would expect grease to pass through. Push come to shove wrap some electrical tspe over the cotter pins. Dan
-
TheOldHokie replied to the thread Land Pride SGC0554 Claw Grapple Grinding Noise??.Drill and tap the pins. #7 HSS drill x 2 = $1.60 1!4-20 HSS tap x 2 = $6.50 Dan
-
TheOldHokie replied to the thread Hydraulic Fitting questions.Let the fun begin :) The losder is the the primary system relief on that tractor/loader combination. It has to be to prevent fully...
-
TheOldHokie reacted to North Idaho Wolfman's post in the thread Hydraulic Fitting questions with Like.
I'll beg to differ with you on both counts. #1 On this model there is no pressure relief valve before the BH loop so deadheading the...
-
TheOldHokie replied to the thread Hydraulic Fitting questions.To test presdure you just connect gauge to backhoe supply and start tractor. Thats the pressure for ALL valves in the system. I looked...
-
TheOldHokie replied to the thread BH92 Hydraulic Thumb.If thats news to the dealer consider finding another..... As Russell said. Disconnect both hoses with grapple open. If it closes the...
-
The issue is resolved! and now i know what it sounds like when my rear hydraulics are dead ending. I made the adjustment. Also the Roo...