TheOldHokie's latest activity
-
TheOldHokie replied to the thread LA344 Single Point hydraulic connector leak.I thought the conversion was to replace both sides with standard couplers. Lot of folks like the flat face type. Dan -
TheOldHokie replied to the thread Rear Remotes.I am guessing draft control lever. The owners manual should detail all of this in gory detail. Dan
-
-
TheOldHokie replied to the thread Kubota RTV900 hydraulics.That mod is a recipe for pump failure. There is no place to store the oil needed to extend the cylinder. When you extend the cylinder to...
-
The tank is under the bed, between the frame rails at the rear of the unit. The #2 reference in the circle is the fill/check cap on top...
-
TheOldHokie replied to the thread G5200 (D600) drain cock valve thread pitch.You would not notice but the threads would be imperfect. You can even jam some sizes together right out of the box but the pitch...
-
TheOldHokie replied to the thread G5200 (D600) drain cock valve thread pitch.Not only is thread pirch different the flank angle on BSP is 55 degrees vs 60 degrees for NPT. They DO NOT INTERCHANGE. The diameters...
-
TheOldHokie replied to the thread M7040 3 point weakens throughout the day.I would suggest a couple simple tests. Conduct each test before the oil is warmed up and again after its warmed up and you are loosing...
-
TheOldHokie replied to the thread M7040 3 point weakens throughout the day.Something in your hydraulic system is bypassing oil when the oil warms up and thins out. The two main suspects are the 3pt lift cylinder...
-
TheOldHokie replied to the thread Kubota RTV900 hydraulics.There is a hydraulic tank somewhere on the machine. Have you consulted your Owners Manual? Dan
-
-
TheOldHokie replied to the thread Kubota RTV900 hydraulics.I think that is a serial number not a model number.
-
TheOldHokie replied to the thread Lose bolts The bolts.Loctite High Strength is red. Dan
-
TheOldHokie replied to the thread Kubota RTV900 hydraulics.Many different variants of the RTV900. I looked at a couple and they had a hydraulic tank. Whats the full model number of yours. Dan
-
TheOldHokie replied to the thread M8200 Coolant Flush Question.Bizarre - another bit of Kubota trivia. Dan
-
TheOldHokie replied to the thread M8200 Coolant Flush Question.I think that's supposed to be hollow. Have you tried to open it up? Dan
