Recent content by thecoopers

SDT, I think that your thinking and a previous post are telling me correctly what to do. I am going to check and see what the washer installation looks like and compare it to the other blades. Thank you.

BruceP, Thank you for sharing your thinking. This very well may be the problem as there are two washers with a cupped effect. I may be installing them incorrectly. Although, I do believe I installed all the blades the same. I will check.

I would appreciate some direction. Have a Kubota rotary mower (RCK60-29B).Mounts on a B2920 tractor. Middle blade is causing a problem. It won't tighten and slips and causes noisy vibration. The other two blades are operating fine. I have taken it off a number of times and reinstalled and...

Thank you for your thoughts. It seems like the direction that you were going is what solved the problem. I sprayed lubricant (as suggested by another forum member) onto the lock lever for the loader and it freed up everything just fine. Question? What is WSM? _______ Service Manual? Where...

Thank you for your direction. I did spray the lubricant; and it did free the lock lever. It also allowed the loader to work when I tried it again. Interestingly the loader is moving smoothly like it should and not stiffly as it has been acting in the recent time of the last week or so. Case...

Thank you for your thoughts to help me. The fluid is correct. The three point hitch lever looks centered. Coupler and hoses OK (never been disconnected) I will keep that thought though for the future. Per the direction of another gentleman to lubricate the loader lock (which somehow got...

The tractor (loader has never been off) is stored in a shed all the time. I have washed the tractor on occasion. Where you referring possibly to the rust issue mentioned below? Thank you.

Thank you for your interest in helping! The loader model # is a LA364. Interestingly, when I went to confirm the number of the loader, I checked the "valve lock" because I noticed it in the loader manual (I have never used the lock) and found it in the locked position. I have looked in both...

We have a B2920 with a front end loader. It has worked well, then for a period of time it would "temporarily" stick, but by raising or lowering the three point hitch, it would work again. Recently, instead of the fluid movement of the joystick, I would have to bear on it more to the right and...

Thank you for your reply. Where would a person find the free download of the parts manual? Thank you, Joe

So ... putting the debate of pros and cons of safety switches aside, does anyone know if the switch can be adjusted? Would spending X number of dollars to purchase a manual tell me how to adjust the safety switch? What should I do? Thanks, Joe

Our B2920 Hydo Kubota has experienced chronic starting problems for many months. We have been putting up with it, wiggling things to get it started. It seems as though I have localized the starting problem to a part located under the forward/reverse area of the deck (where your feet rest while...

Thank you for offering your thoughts and suggestions. Yes, the relay did seem to help for a while. But of course the tractor worked when we took it all the way to GA. to get it serviced. I really don't have a base of knowledge about 12 volt electrical wiring on auto/tractor items. I will...

It happens 85% of the time. More so after the tractor has run and then shut off and tried to be restarted. Although it is not uncommon for it not to start initially.

We have a B2920. Have had starting problems for quite awhile. We have taken it to the dealer and they couldn't find the problem. We put on a relay on the starter which we thought might help. The problem has returned. Presently if you play (for minutes) with the forward/reverse pedal it will...