Recent content by thackney

If you would help me with something stupid, I bought the fuel lift pump but cannot figure out how the electrical connector comes apart.

I disconnected pump from the tractor body and removed the discharge hose. I can feel the pump trying to run in my hand, vibrations. No diesel discharge. I took off the intake hose and diesels flows freely from the water separator to the pump. I could not blow air through the pump forward...

I have followed the instructions. I did not see any diesel come out the bleed vent like I expected.

Well, thank you for taking the time to educate me. I have not seen the wires while going over the actual part but I have not taken it apart. I replaced the fuel separator and the fuel filter. I had an algae problem, but after replacing it never starts, while turning over. I will take it...

It has no wires.

Thanks, water was only 4 inches deeper than shown in the photo. Just over the foot rest on the L3901. It was at the oil filter on the B7100. I will likely need to hire the dealer to service. We have our hands full.

I would like to solicit suggestions for my L3901 and B7100. Both are still in floodwaters from Harvey in Brazoria County, Texas, south of Houston. Please see the attached photos. Water was 4 inches deeper at the peak of the flood. We still have a foot of water in the house, so life is rather...

What model of lights did you use? Lumen output? Looks good and lots of light in your pictures.