Recent content by sonny4954

i give up. getting info on the l3500 is just not going to happen.thanks to all that tried to help. see ya

i don't know about your l280 i have a l3500 my water pump went out two years ago i had our local parts store send it off to huntsville, al. they mechined the housing out to except american seals. it cost me just over a hundred bucks.

hi gordo i don't rember what filter i use in my l3500 but i think i may have the box out in the shop i will look in the morning but it is a comon filter.seems like i had to use the top off the old filter.

hello gordo. i am glad to know that my l3500 is not the only one in the u.s.a. i like you am having a hard time with parts. my tie rod ends were so bad they were falling off so i welded large washers over them so the ball would'nt slip out. if you find out any thing about them i would like to know.

good morning vic here are the numbers off the pump they are the only numbers left on the engine that i can find. 090800-0532 and below that 275-1250 hope this help.

hi vic i will try again in the morning. there is another tag on the govener end of the injector pump i will check it out. none of the engines in the chart looked like mine. i think it is a 1976 year mod. this dose show where i got these numbers

not looking for connecting rods i need tie rod ends

hello vic here is what i see on the pump. "no pes3a65b410rnd230" then below that 090000-2303 and below that 9m0010

thanks for the help guys. i went to my local kubota dealer today he ordered one but not sure it will fit so i welded my old one up and put it back on the tractor i think i got a pretty good scald on it but if i can get the new one i will put it on and save the old one for next time.

good morning traildust. didn't really mean to sound like a horses a. and i am always open to new ways of looking at a repair. i was hoping some one could tell me if kubota used this engine in something sold here in the us. there is no english writing in the engine that i can find only 1908cc

if this was ment for me ole son don't worry about the mule just load the wagon if not then have a good day

thanks. for the welcome

sounds like a winner to me. i worked a lot of years as a pipe line welder and about the same amount of time in a mechine shop. the last few years i have lived on the farm and just fix farm and logging equipment for the local folks .don't make much money but at least im here to see the grand kids...

well i guess i started welding about the same time you did i have welded more pipe than you can shake a stick at and burned my share of ni rod on cast. i might be able to fix this manifold i haven't tried yet just thought i would replace it if i could find one. I will try to get a pic or two if...

yes i still have it i just broke it off today.i am a welder by trade but it is in a mess with all four corners broken off.