Recent content by snowpiler

Thank you very much. There was no mention of this in the manual.

I put a drawbar lock on it to keep it from spinning using a 4 inch clevis.

I want to lift the mower deck and keep the drawbar in place.

Got a fel dollie from bxpanded. Works great!It comes with good instructions for newbies.

This is a photo my wife took. It took a little doing adjusting shims to its width, compounded by the the company sending the wrong u-bolt nuts - good thing we have a nearby hardware.

Yesterday I added a sunshade. Got it from Northern Tool through Amazon. Took some work with shimming to fit. We will see how it lasts. $150.00 + shipping.

Bxpanded quick hooks are simple strong and easily installed.http://bxpanded.com

Thanks. I've operated a lot of heavy equipment and every thing else in between, but I've never had so much fun as with my little kubota.

In the past few months since my purchase of the 2012 bx1860, I have added several items you may be interested in. A vertical plastic tool case, piraña tooth bar, "easy on" bucket hooks, trailer hitch, load carrier and tooth bar shield. Some have been easy to install. Others, not so much. All...

Great look! Next is a tooth shield to protect those shins when not in use.

According to the mower manual, the bolt is 30 mm - 72 to 87 ft-lbs or 98 to 117 N-m. of torque.

My wife (Jerseygirl01) and I purchased a used Kubota recently to assist in chores around the property. I took the mower deck off so I could use the tractor to haul snow (we get 150 - 300 ins. of snow seasonly). The problem we encountered was stated above. The solution was to run the mower hitch...