Recent content by Serp0421

I’m hesitant to buy the ends from tractor supply and the ends I saw there were not the same thickness.Would a Kubota dealer have these ends or where do you recommend I find some the same size?

Thanks I’m gonna check them out.

I haven’t. I may look into that. I’m down in Louisiana and most of the online salvage places I see are way up north. I’ll have to see if they can ship parts.

Also sorry about the “eyeball, lower lip” visual I gave you. Im gonna straighten the lift rod then probably run the “lower lip” until it comes apart then buy a new one. I saw a video of a guy that laid a few beads down around it and hammered it over while it was still glowing. I just figured I...

I’m just being cheap and don’t feel like spending $400 on a new one!!

I have an l4150. The left lift rod was bent when I bought the tractor causing the lower left link to ride on a cocked angle when hooked to an implement. This has caused the ball socket on the lower link to become worn out. The ball has a lot of play and seems like I could knock it out with a few...

That was it. I figured it out last week. I took off the seat and pb blasted the the adjustment rod right where it goes in the rear end. I tuned the knob a little more and I could here fluid leaking back and the 3pt started falling. Happy that’s all it was!

I just got this tractor not long ago. I know it sat up for a few years. I don’t know the maintenance history but the engine and trans oil look clean. I plan on changing all the fluids and filters but just haven’t got to it yet.

After working the throttle back and forth and some lube it was doing a little better. I could get it to about 2150 rpm. The 540 PTO mark is at 2250. I definitely can’t go any past that. The lever on the injector pump or throttle is bottoming out on the adjustment screw that has some kind of...

I’ve got an ole l4150 I’ve gone thru and got working properly. If I push the throttle all the way it seems to rev accordingly but my tach it never gets up to the 540 PTO mark. I’m assuming it’s a faulty tachometer. Thoughts?

Someone told me it’s good for a finish mower because it turns up a little faster. Not sure how much truth there is to that.

I have an l4150 that has 540 and 750 rpm pto. I am not sure when to use 750 instead of 540. Is it an attachment thing or an efficiency thing?

So where is this screen for the hydros? Is it behind/ inside filter housing or is it somewhere else on the tractor. I see what looks like to big plugs under the rear end bit not sure which is which?

Yeah I tried that! They leak down over night!

Spot in with the PTO!! This morning the 3pt was down. I made sure the release valve was open and I was able to het it to come back up but nothing after that. Looks like I’ll have to do what theoldhokie said and do some studying.