Russell King's latest activity
-
RRussell King replied to the thread G21 MOWER: Cutting Height Adjustment Dial & Cam.I have NO real idea or experience with what you are talking about but there have been some discussions on here on how to remove lever...
-
RWelp...It runs!! As a matter of fact it runs pretty nicely too! Hard to believe that just 7 days ago this was a rusted relic frozen...
-
RRussell King replied to the thread Over Heating.Clean the screen in front of the radiator if there is one.
-
RRussell King replied to the thread Rain in fuel tank..For the fuel in the tank I would agree that it is best to drain it out. There may be some way to pump it out but then I would still...
-
RRussell King replied to the thread Messicks, reinvents black electrical tape/duct tape..From what I see there is a flat surface that sets down onto the top of the neck. That is where it appears to “seal” to me.
-
RThanks for the guidance! Called my dealer and they're looking into it.
-
RYes ok , fair enough. I do have workshop manual and it says nothing about shimming the relief valve that I can see. I've seen videos of...
-
RRussell King replied to the thread ISO ROPS for L345DT.See post #37 in this thread. @MGnoob says the ROPS is available through Kubota until December...
-
RRussell King replied to the thread Need a little help swapping brushhog gearbox.That definitely looks like a string from a round bail to me. You might be able to straighten it out or clean it up to see it better...
-
-
RRussell King replied to the thread L4200 pto problem.Gjackson has not visited the site since 2021 so doubtful that you get a response from him! I would guess that a relief valve is shimmed...
-
RReporting back. Russell King, you are a badass. i installed a new negative cable when i replaced the battery because the old one was...
-
RIt's a different model with a different manual, and the directions are reversed.
-
RRussell King replied to the thread Need a little help swapping brushhog gearbox.I have no idea how to answer your questions but do know that rotary cutters are known to wind all sorts of wire and strings around that...
-
RRussell King replied to the thread Help me Shift L3710 out of 4WD.The manual posted above say ON is DOWN and OFF is UP. See below. Is yours reversed to that manual? If so the use a forked stick to...
-
-
RRussell King replied to the thread Cleaning Underside of Mower???.For a good way to make ramps from woos see this video. Omit the hinged part if you don’t need the access from the sides.
