Recent content by rroberts

  1. R

    LED Light bar L3560

    I did a curved bar upfront and 2 pods on the rear.
  2. R

    Tweaked Box blade

    Quick update, I had the box inspected and it did indeed bend mounting point that the blades bolt to, the whole piece has shifted forward 3/8", It's going to the welders shop to be fix and ad some reinforcement bracing. That 3/8" was causing the rear blade to hit the ground long before the front...
  3. R

    Tweaked Box blade

    I will get pictures later, you can adjust the top link as much as you want and the front of the box bottoms out while the front blade is still 1/2" off the ground. Everything was fine till I was backfilling a hole and caught an unseen object and now it's out of wack.
  4. R

    Tweaked Box blade

    I managed to tweak the scraper blade mount on my box blade, when the box is level on a level surface the back blade touches before the front blade, I had to take the back blade off to finish my work, any suggestions on how to get it straightened out?
  5. R

    Shaft won't go on PTO spline

    I found the issue, there was paint in the pin from the factory, I used a screwdriver cleared out the paint and worked it a few times (about 100) and now it works. The paint was stopping it from depressing all the way, it was stopping about 1/32" short.
  6. R

    L2501 Cruise Control

    I made it by the dealer this week, There are 3 tension bolts, the cruise control works off tension nothing else adjusted those and everything is fine now
  7. R

    Shaft won't go on PTO spline

    Just bought the land pride tiller and I can't get the shaft to go on the PTO, it has the push button type release and I have cleaned it and oiled it. It goes on about 1" till it hits the bar connected to the button, I push the button and it just won't go on at all. Suggestions? Thanks in advance
  8. R

    L2501 Cruise Control

    Thanks everyone, I will ask my dealer and see if they will swing by and adjust it
  9. R

    L2501 Cruise Control

    I searched and didn't see an answer for this, I just got a new L2501 last week (Love it by the way) but the cruise control does not work how I think it should, I set the speed with the lever and when I let go it slowly backs off till it stops, if I hold the lever in place all is fine...