Recent content by Rickyboy

great explanation . i don't know about your model but i cracked the input shaft housing on standard drive and had the similar issue till it busted fully out.

i don't go with that science stuff i just measure the how wide top length on the implement then how far it is to the implement attached. i give my self some extra . im sure it sounds crazy but i dont know how to draw a picture .

first thanks guys for letting me join . second my spelling is a mess ill try to correct it . i have l3901 dt a few weeks ago i noticed a slight loss in power while working. it worked ok in low but didn'ti have any pep some times. i loaded Mable took her to a church needing a parking lot...

made sence to me

i just replaced the double clutches in my l3901 dt . tractor now it wont roll the engine over fast enough to start . i have replaced the battery, clend the grounds and checked the fuses . none of these have worked. i removed the starter and grounded it seem to spsin fine . i was wondering...