Recent content by RedTailHawk

I've had this on my watch list for a few years. Still haven't found any customer reviews, and only a couple YouTube videos of it in use. Anyone hear have one that can give feedback?

@Dave_eng - you da man! Thanks so much. I've already placed my order at Messicks and should have the parts early next week. Have a great weekend.

Every place I've searched has a clevis pin, which has a standard round head. This pin I'm trying to find has a larger, oblong head.

Anyone know the name/number of this pin? This is in the lower arm of the 3 point hitch on the back of my Kubota L3430DT-F. The pin size is 5/8" x 2".

figured it out. There is a dial right under the seat. It just says On and Off. Doesn't say what it controls. Anyway, turned it to on and the rear 3pt hitch hydraulic now works.

The attachment is just a landscape rake (no PTO hookup) Sent from my iPhone using Tapatalk

Yesterday I was all set to work on my food plot, but when I got my L3430 to the field, I noticed the rear 3 pt hitch wouldn't lower. Moving the lever back and forth, it raised a little more until it was all the way up, but it wouldn't go back down. (I thought I had seen a thread on this a few...

I just added one recently and use it all the time. Used it as a scraper to remove mountain laurel and small tree stumps from a new mountain side food plot. Dug up an old rusted out road culvert and installed a new one. Wish I had gotten the Piranha a few years ago. Also, I did get the step...

Used shovels to get dirt down and around the culvert. Used the tractor to finish covering it up and packing it down.

did everything with mine over the weekend... cleared a mountain-side food plot, (dropped a tree on it, and it survived without a mark), dug a trench to divert mountain-spring runoff from flooding another one of my food plots, installed a galvanized culvert in the road with my son and nephew...

For those that mounted the switch on the front dash, how did you run wires from the ROPS to the dash? Did you go under the tractor frame or just tuck it under the rubber floor mat?

I was wrong. There is a hi and low beam on these bulbs. They work great. Way better than the stock bulbs.

Ok. I'll give it a shot. However, I'm wondering how to physically connect at least 2 sets of wiring harnesses to the one factory OEM plug. It has (2) 1/4" spade connections, one turned perpendicular to the other, sitting inside a green plastic casing. Should I just remove that plastic green...

It doesn't specify the amps on the product page (http://www.ebay.com/itm/301636592258?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT), but each light is 18W, and operating 9-32V. So I believe the amp draw is anywhere from .5 - 2 amps. Does that sound correct? Actually, I'm not...

For me, I'm wiring in 4 LED cube lights, and a combo Voltmeter-USB port-Power socket (http://www.amazon.com/gp/product/B00WLFU7QY?psc=1&redirect=true&ref_=oh_aui_detailpage_o07_s00) My main interest in a separate fuse block is that I don't see how wiring into the rear accessory plug on Kubota...