Recent content by ravensview

Thanks for the reply’s, I figured it would work with the backhoe on but wasn’t 100% sure, and was watching videos of installing the skid plate, it seems like the mower height adj arms need to drop down and it looked like the 3ph and those arms could cause this movement to not occur.

A couple of quick questions, 1) does the backhoe have to be removed to install the skid plate? 2) can the backhoe be used with the skid plate installed? I am thinking that it can be used while installed but do not know for sure

Good Luck, I have had to disassemble my snowblower a couple of times already, replaced the impeller twice, doesn’t take much to make it go Caty wumpus, between a long gravel driveway, living in a wooded area off a dirt road, with two dogs who leave chunks of firewood everywhere and lots of...

My bx23s has done all that I have asked of it and more, just have to plan out the attack on the task well, are there times I wish it could lift more-yes, are there times I wish it had higher ground clearance - yes, etc… , but for 90% of the time it does what I ask of it and more. When I was...

Looks good, I drag an old gate off of my trailer it’s expanded metal and I just tie it off the back of the tractor takes several passes but it does a pretty good job of smoothing down the driveway, my driveway is around 300 yards long with a slight grade to it

That would be nice, I haven’t found a non fuzzy one yet for bx23s.

Was able to do this today, seems to have worked, I was figuring it had to do something with the cable adjustment, but the friction adjustment was an even simpler solution, thanks

Thanks for the video, seems to have solved the problem

Awesome, thanks will give it a try tomorrow.

Hello All, I’ve got another quick question for the forum, I have a bx23s and lately the rpm’s have been slowly dropping off while running. I warm up the machine till it registers on the white temp gauge, then when I throttle up to run, 3200 rpm’s or so it runs at that rpm’s but slowly drops...

Yep, I had to slightly bend the metal on the housing where it hit, I’ve run snowblowers for 50 plus years and never had this happen before, that shear pin should’ve prevented it, I am regretting going with the 2816 instead of the heavier duty model, I’m thinking that this 2816 is more of a...

I had the same thing happen to mine, I hit a piece of firewood that one of my dogs had been playing with and it got buried under a snowfall, anyways the shear pin went but not before one of the fan blades bent, I was able to bend it back and ran it till I got another fan unit, am going to do a...

So just an update, our temps finally climbed up into the 30* range and I went out to the garage to try and start my tractor up, it would turn but not fire, fuel pump sounded like it was pumping fine, fuel filter had fuel in it, rapped on the fuel pump a couple of times, then loosened up gas cap...

Okay, I pulled the secondary fuel filter (one closest to engine) back off and placed a pan under it, then turned key to activate pump, it sounded like it was pumping but diesel was just trickling out the end of the filter, so I added some biocide to the tank, will retry to start today. I...

Around 100 hrs of use, which was 11/2 year, I use the diesel fuel additive that comes in a white bottle that is similar to 911 already, is their a different additive that I need to add?